Question about 2003 XLH Sportster 883 Hugger
...lever spray lithium grease on switch button and make sure housing for throttle and switches are as tight to brake handle clamp as possible. Also if there is the mechanical lever in brake clamp the ...
Question about 2003 XLH Sportster 883 Hugger
...and easy to replace. while you have the lever off check the brake switch for proper function- it should switch on and off easily with just a simple push and release of a small screwdriver or
Question about 2003 XLH Sportster 883 Hugger
pull out carefully and disconnect wires.Hook up wires to new switch and reconnect in reverse order.Oh yeah,the switch is behind the lever in the reservoir body.No need to remove brake cable from lever
...Wiggle the front brake lever in and out to see if the brake light goes out. If not, it could be the switch or a worn out lever or, brake lever and switch housing are not properly seated
...switch. When the lever is pulled, it pivots on the pivot pin and small tang on the bottom side to the lever swings FORWARD releasing the swith turning on the light. When you let go the tang swing ...
...lever has a switch located in the right handlebar switch housing. When you squeeze the lever, a pad on the lever moves forward allowing the switch button to move forward making contact which in turn ...
...switch my be bad or the lever has too much wear in it and should be replaced. There is another switch in the system for the rear brake. Follow the metal brake line coming out of the rear of the rear ...
Question about 2006 FXSTI Softail Standard
...the switch in the side of the switch housing facing the front brake lever. Your front brake switch may be broken. Odds are that the front brake switch is the one causing the problem. Good Luck ...
...the switch in the side of the switch housing facing the front brake lever. Your front brake switch may be broken. Odds are that the front brake switch is the one causing the problem. Good Luck ...
Question about 2000 FLSTC Heritage Softail Classic
...pushes the lever back but the lever operates the front brake light switch. If the lever and it's pivot pin are worn, the lever will not come back far enough to depress the switch. Good Luck ...
Usually answered in minutes!
681 Questions
595 Questions
586 Questions
644 Questions
456 Questions