Questions & Answers for: Chrysler lever switch

Question about 2004 Sebring

1 Answer

...lever, tilt the column down. Remove the two mounting screws on the switch and remove the switch. Remove the wiring from the hooks and disconnect the two electrical connections on the multi-function ...

Ad

...lever is not disconnecting the switch properly) To see if it the pads, jack the front of the car up, lever the pads away from the discs, and if the light goes out, the pads are worn, if it doesn't, ...

Ad

...lever. If you have cruise, let it hang. Remove the hazard warning switch and upper bearing retainer mounting screws. Pull the switch from the column carefully, guiding the wires through the column ...

...off, or in accessory position :- if so, you may have a faulty brake pedal / gearshift interlock switch. (With ignition off, temporarily move lever to neutral to enable engine start for vehicle

...switch . If the starter will operate. the park gate position is correct. Move the shift lever into the neutral (NJ position. If the starter will operate in this position, the linkage is properly ...

Question about 1997 Sebring

1 Answer

get it out of the way. Remember to set the park brake first. Could just be a bad switch or loose connector. Check fuses and the bulbs. Is shifter fully in Park? Also try jiggling the turn signal lever

Question about 1997 Sebring

1 Answer

get it out of the way. Remember to set the park brake first. Could just be a bad switch or loose connector. Check fuses and the bulbs. Is shifter fully in Park? Also try jiggling the turn signal lever

Question about 2004 PT Cruiser

1 Answer

...dash of a 2004 PT Cruiser? On the Multi Function Control Lever (Turn signal Switch lever) there should be a center section that will rotate to control the dash panel light brightness, and dome

Question about 2004 PT Cruiser

1 Answer

...switch that senses a lever/arm inside the trany. I used a Ohm meter and confirmed the resistance did not change whether the switch was activated against metal or not. may be you should make a ...

Question about 2004 PT Cruiser

0 Answer

...does not come on when parking and head lights are on. Bulbs changed, same result. Could it be the light switch/turn signal lever? Could be the light switch/turn signal lever (aka multifunction

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Chrysler Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

john h

Level 3 Expert

29494 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...