Questions & Answers for: Black & Decker lever switch

...the orange lever came off. if thats the case you need the switch housing assy & a spring. the lever was held by the plastic housing pin or pig. some times the plastic pin worn out before it

electric lawnmower handle is hard press which starts the lawnmover switch problem also checked the pin housing that holds the orange lever if not worn out. if is worn replaced both.

...the wiring so I removed the on-off switch lever. The wiring appears intact. Part of plastic inside the lever maybe broken. Can i use the mower without the lever by just pushing the black

...switch terminal facing you & the black round lever facing up postion.now all left side terminal are for red & white. next step all right side terminal are for 2 black wire. doesn't matter the red & ...

...switch lever and make sure it is inside the slide selector lever. If that isn't the issue, I'm afraid that the electric trigger/switch has failed and this isn't a part that can be disassembled and ...

...switch and arm pivot failure Bless you for posting this photo. I took one but my cellphone ate it, and there is no good way to know for sure which wire goes to which. Do I see a metal pivot for the ...

switch and still does not work. Is there a reset button on the motor or any ideas? checked the house breaker, electric extension cord and outlet - all ok there. The "wedge" of the plastic lever wears,

cmm1100.... it's charged and i work the tw levers on the handle...is there something else i need to do....i pull back on the on handle and press the run handle forward and nothing happens The problem ...

switch lever. The wiring appears intact. Part of plastic inside the lever maybe broken. Can i use the mower without the lever by just pushing the button? you could just try drilling the case out where

switch lever would only work when held at a angle. I opened up the switch cover and found the plastic pivot pin for the switch lever was worn causing the lever to be too loose. I cut the pivot pin and