Questions & Answers for: Jeep Wrangler 2 8 tps replace

...if i was letting off the gas and hitting it real quick. I took it to auto zone they said it was the tps. I took it to a mechanic he said it was loose and he tightened it. Im now getting the same ...

i have a 2004 jeep wrangler that is throwing a p0123 tps volts high code i have replaced the sensor and it is still coding. and ideas thanks did you rest the code after replaceing the snsor?

where do I plug in the OBD2 sensor to pull engine codes?? we just has the TPS replaced and the pigtsail checked. We borrowed an OBD2 to try to see if we can check ourselved, but can not find where the

CHECK ENGINE light won't go off. Analysus says CHECK ENGINE light won't go off. Analysus says TPS but have replaced TPS Twice, Disconnected Neg on Battery for reset and light still comes on . Says TPS

replace TPS and re-check. 4. If you have no TPS signal, check for 5 Volt reference at the connector. If it's present, check the ground circuit for open or shorts. 5. Make sure the signal circuit isn't

I need to set the tps The throttle position sensor on a Jeep Wrangler is not serviceable.  It must be replaced if bad.

......checked egr valve, plugged it off....replaced heated oxygen senser....checked voltage going into tps, read 5.0 voltz, coming out 1.40 to 4.60 voltz moving the throttle from idle to full throttle, ...

...wires, fuel filter etc It could be a combination of 2 things. A faulty MAP sensor itself or a bad TPS (throttle position sensor). It's not uncommon for a bad TPS to idle when the motor is cold ...

...Plugs-good no sign of lean condition replaced upstream 02 sensor replaced MAP sensor replaced TPS replaced IAC New converter It has a few modifications Throttle body spacer Short ram intake ...

I have a 1999 Jeep Wrangler 2.5L. I just replaced the TPS about 2 months ago. A few days ago, it started idling really high again. This was after it sat in the driveway in the rain.I took it to ...