Questions & Answers for: Ford Ranger 2 8 tps replace

...replace dist. cap and rotor all together. no more problems. check it out. try wd first. pull cap off and look for corrosion i bet thats your problem.hope this helps I had the EXACT same problem, the ...

...Replace the IAC (Idle air control) Check TPS (Throtle Possition Sensor) Check for any other vacuum leaks old rubber hoses are bad to rot and let extra air flow into the intake. Please rate this a ...

...Need to know what to set it to to run correctly. Ok in the Haynes Repair Manual it say that the TPS sensor is non adjustable on a ranger. Now if you have an adjustable one you have a TPS block ...

I'M GETTING CODES 118,123,113,522,341 I HAVE REPLACED ECT,TPS,IAT SENSOR AND I'M STILL OUT OF RANGE ON SCANNER AND WHEN VEHICHLE IS HOT IT WON'T START.IT CRANKS FINE I HAVE GOOD SPARK AND 35PSI FUEL ...

how to replace the tps on a 2005 ford ranger tps is located on the throtle assembly ajasion the linkage cables two screws and pop off the pigtail wire and there you go

TPS,FUEL PRESSURE REG ..still cuts out when cold and stalls try to rev to 3000 rpm cuts on and off but when warms up have no problems ,been told fuel pump but has 2 low psi and high psi pumps what one

What is Codes PO122 & PO303? P0122 = TPS (throttle position sensor) voltage reports too low. This means that you could have a problem with the TPS, the wires to the TPS or the computer, if you ...

...TPS Sensor,was replaced after you tested it ,and found it defective? Spark Plugs-ever hear of one failing. Never seen one fail in 47 years. Have you considered the EGR Valve,Vacuum Leaks,Old O2 ...

my 89 ranger runs when you pour gas in it. replaced fuel pump.pressure reg, tps, computer .still the same wont run pump only runs for a little while. fuel pressure is to low why is fuel pump shutting ...

...back up as throttle steadily pushed, then replace the TPS. If the needle slow and steady moves up /across and no stumbling, the TPS is probably ok.  Make sure you test it a few times at