Questions & Answers for: Chevrolet Impala 2 8 tps replace

Question about 2001 Impala

3 Answers

...P0507-- idle speed high how do I diagnose the code ? where do I start to look P0507 2002 Chevy Impala 3.4 eng. Code P0507 I have replace TPS & Idle Air Control Motor, and Intake Plenum ...

Ad

...fine when cold or will restart after it cools down and run until the engine warms up, have your TPS (Throttle Position Sensor) replaced. I have seen quite a few lately that will "warm" up and ...

Ad

When I press the accelorator pedel I get no response TPS SENSOR WORN NEED REPLACEMENT

my impala will start only if i hit the gas and only stays on if i hold the gas your throttle position sensor (TPS) is bad. replace for around 30 bucks and 5 mins ofyour time.

...fluid and then check your TPS (throttle position sensor) Check TPS for smooth and linear electrical response over the entire range of motion. If not, replace. Thank you for using fixya and good ...

Question about 2003 Impala

1 Answer

...TPS sensore code is coming up..replaced the APP sensor, and still getting the "service traction control" and "engine power reduced" messages. I am about to replace the throttle ...

Question about 2007 Impala LS Sedan New Cars

1 Answer

...replace the TPS, then if it isn't solved, try the APS. If changing both doesn't solve the problem, maybe a wiring harness problem from these two sensors that input to the Transmission and Engine is ...

Question about 2003 Impala

1 Answer

...REPLACE TPS, MAP SENSOR, IAC MOTOR AND CLEANED THROTTLE BODY, PROBLEM IS INTERMITTENT To me it sounds like the (fuel pressure valve) located on the end of the fuel rail, by the throttle body, also ...

Question about 2006 Impala

2 Answers

...replace the tps ? The TPS is mounted to the throttle body on the intake duct.It will have a connector and held on by 2 or 3 screws all vehicles are different.Remove the connector and the 2 screws and ...

Question about 2003 Impala

1 Answer

replace TPS and re-check.4. If you have no TPS signal, check for 5 Volt reference at the connector. If it's present, check the ground circuit for open or shorts.5. Make sure the signal circuit isn

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Manuals & User Guides

Loading...