...camshaft postion sensor? Most likely yes. It's not that the cam is out of position (that's controlled by the timing belt, so as long as the belt hasn't slipped, the cam is where it should be). What's ...
...camshaft positioning sensor was bad and needed to be replaced where is that located on a 2004 hyundia elantra 2004 On 1995 and later models the CKP is located at the rear of the engine near the ...
something in the wiring inside the sensor goes bad. Not usually any signs, they just seem to go out randomly. Not sure how hard they are on the hyundai's, but it should be somewhere on the valve cover
...warm,it takes4 or 5 attempts to start, changed camshaft sensor ,but still the same problems persist, hyundai accent 1.3petrol manual 1999 model. Fuel filter partailly plugged, or bad spark plug
...hyundai amica si car is running badly,stuck in limp mode,almost like constant 1st gear fault code 0343 camshaft position sensor fault code 0444 purge valve where do i find these parts in the engine ...
...Hyundai Santa Fe. The owner said they were driving and it just quit. It still turns over but doesnt fire. There is spark and compression. The timing belt is not broken but is cracking (needs to be ...
...hyundai santa fe with 2.7 v6 that turns over alot longer than it should before starting alot of the time and then has a smell of gas and sometimes starts right up like normal, I am wondering about ...
hyundai accent turns over but won't start It could be a lot of things. These cars do however have a history of bad crankshaft sensors. Start there and also check the camshaft sensor. I would need much
Question about 2007 Accent GS Hatchback
...Hyundai Excel is stalling than not starting till after it sits a while, has anyone any suggestions please Have checked immobiser spark fuel filter etc. Bad crankshaft sensor...Bad camshaft ...
Question about 2007 Accent GS Hatchback
...Hyundai elantra don't want to start while it hot In my experience, the likeliest cause is a bad crankshaft or camshaft sensor. When it happens, try opening the hood and letting the engine cool down ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions