...been doing this over a month i had my fuel pump tested they said the fuel pump is good check your crankshaft position sensor it may be gone ...
where is the crankshaft sensor on a 1994 Oldsmobile 88 On the passenger side behind the crankshaft pulley. You have to remove the serpentine belt and crankshaft pulley, which is best done through the ...
...every 40-40 and before that 60-70 ,wait 10 minutes & it restarts this is caused by a defective crankshaft position sensor which causes a loss of ...
...for them. They had taken it to a shop. The shop could not duplicate the problem but replaced the crankshaft sensor hoping that would fix it. The problem continued. I get the car and i put a new ...
need to replace the crankshaft position sensor REMOVAL & INSTALLATION Disconnect the negative battery cable. Remove the serpentine drive belt from the crankshaft pulley. Raise and safely support ...
...the problem may be These cars had a very common problem with a sensor that is mounted behind the crankshaft pulley. It is difficult for the home mechanic to change as special tools are required, ...
gve wrong e-mail add.... need to install a crankshaft positioning sensor -- is this a do-it-yourself job? how? This is best done by a shop. To change the crank sensor, you'll need to have a puller
Question about 1996 88
...trying to start it. Oil change about a month ago. Not sure? Timing chain, cam position sensor and Crankshaft position sensor. Check them ...
what make my 1989 delta 88 cut off when i put it in drive Had same problem on a 1995 buick , problem was crankshaft position sensor
Usually answered in minutes!
14 Questions
256 Questions
248 Questions
219 Questions
204 Questions