Questions & Answers for: Honda Accord 2 4 crankshaft

Question about 1992 Accord

2 Answers

honda accord ex 92 how do i change the harmonic balancer? Crankshaft pulley (harmonic balancer) removal- disconnect neg battery cable, remove belts, it would be a good idea to soak the bolt w/ ...

Ad

1996 HONDA ACCORD CRANKSHAFT SENSOR AND CAMSHAFT SENSOR. My 1996 Honda accord threw a code for crank shaft sensor last year i refused to fix it, now it throws a code for camshaft sensor and my carmd ...

Ad

...do with this also,if it has them,if not it can be the wear in the cam carriers.But most likely the crankshaft journals are worn to much,the crank would need turning,and over size rod,and main ...

how to replace Honda front Crankshaft Seal how to replace 95 Honda accord 2.2 front Crankshaft Seal Have to take off the crankshaft pulley to get at the Crankshaft Seal. Use a hooked seal remover to ...

...Record anti-theft code for radio. Disconnect battery negative cable then positive cable. Turn crankshaft pulley until TDC is achieved. Raise and safely support vehicle. Remove front tire ...

Question about 1991 Accord

1 Answer

crankshaft pulley r/r removing crankshaft pulley Place the crankshaft pulley bolt removal tool over the end of the crankshaft bolt. Tool will hold the pulley in place while you apply torque to the ...

...car run but you press the clutch it stall Check with the engine off by pulling and pushing back the crankshaft pulley. By doing so and the pulley comes forward and pushing backwards,there is your ...

Question about 1999 Accord

1 Answer

...check engine light just turned on and engine turned off. what could be the problem. P0336 Honda - Crankshaft Position Sensor 'A' Circuit Range/Performance Possible causes - Faulty crankshaft ...

where is the crankshaft positioning sensor on a 2000 Honda Accord VTEC 3.0 6 cylinder My info shows the crank sensor takes its reading from the front end of crankshaft. You will have to remove crank ...

location of camshaft position sensor on 98 Honda accord 2.3 The Crankshaft Position Sensor for the 2.3L 4-Cyl. engine is located behind the crankshaft pulley on the oil pump assembly. DTC P0335 How To

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

1992 Honda Accord
1992 Honda Accord

2,998 Questions

1991 Honda Accord
1991 Honda Accord

2,681 Questions

1995 Honda Accord
1995 Honda Accord

1,631 Questions

1996 Honda Accord
1996 Honda Accord

1,636 Questions

1998 Honda Accord
1998 Honda Accord

1,570 Questions

Manuals & User Guides

Loading...