Questions & Answers for: Dodge Intrepid 2 4 crankshaft

Question about 1996 Intrepid

1 Answer

...no power to dist coil might just be a bad connection or corroded connection at the coil or the crankshaft sensor. Also could be crankshaft sensor is bad. Start with moving the connector while ...

Ad

Question about 1997 Intrepid

1 Answer

no spark in a 1997 dodge intrepid? With scaner hook up, look at data scoll to cam and crankshaft sensor, should red yes while cranking engine, but more them likely it's going to be crankshaft sensor, ...

Ad

wiich is the torque specifications for crankshaft Crankshaft endplay is controlled by the thrust bearing. Endplay tolerance is usually from 0.004"-0.006" for a crankshaft with a 2" to 2 3/4" main ...

Question about 1999 Intrepid

1 Answer

...Removal & Installation - 2.7L Engines Drain the engine oil. Remove or disconnect the following: Crankshaft damper Timing chain cover Timing chain Crankshaft sprocket Oil pan Oil pickup tube and ...

Question about 1999 Intrepid

4 Answers

...2/3.5L are NOT freewheeling engines. Therefore, care should be taken not to rotate the camshafts or crankshaft with the timing belt removed. Disconnect negative cable from remote jumper terminal. ...

Question about 1997 Intrepid

1 Answer

what is p0016 code in 1997 dodge intrepid.. P0016: Crankshaft/Camshaft Timing Misalignment, A rationality error has been detected for camshaft position out of phase with crankshaft. any problems with ...

What does the crankshaft sensor look like? I have a 99 dodge intrepid, 2.7 l I checked autozone and they shows what it looks like there click on link below at : ...

where is the crankshaft sensor located? You will find the crank sensor on the right side (passenger) just on the back side of the seam between the engine and the transmission where the flex plate that

...a timing chain in my 2002 dodge intrepid SE 2.7 liter .The problem is is that when I hand crank the crankshaft the timing chain goes from tight to loose.There is a slack in the chain on the passenger ...

where is crankshaft position sensor on 1997 dodge intrepid 3.3L Replaced camshaft position sensor because it was bad now the car won't start. Do I have to replace crankshaft position sensor as well ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Manuals & User Guides

Loading...