Questions & Answers for: Plymouth 2 4 crankshaft

do not know how to remove crankshaft pulley to replace timeing belt my timeing belt broke on my 1995 plymouth voyiger with a 3.0 engine. how do i remove the crankshaft pulley to install the new belt? ...

CRANKSHAFT PULLEY CAME OFF HOW HARD IS IT TO FIX A CRANKSHAFT PULLEY ON A 1992 PLYMOUTH ACCLAIM Not a tough job provided shaft etc not damaged.

where is the crankshaft position sensor crankshaft sensor Its on the engine block pointing towards the crankshaft at the one side facing the firewall in most cases How do I replace the crank position ...

...Negative battery cable - Right front wheel and inner splash shield - Accessory drive belts - Crankshaft damper - Lower torque strut - Exhaust system from the manifold - A/C compressor switch - ...

...new distributer,computer,fuel filter,dus cap,plug wires still won,t start what else? It may be the crankshaft sensor.Some cars use sensors that "watch" the crankshaft.When you turn over the car the ...

where is the crank sensor located on 1999 plymouth breeze, 2.4 l double overhead cam? The crankshaft sensor is behind the crankshaft pulley or harmonic balancer. You can access this by pulling off ...

I need to put a crankshaft sensor but I don't Know its location I already changed the cam sensor. Ronnie The crank sensor is located on the engine near the flywheel axis of the crankshaft. Crankshaft ...

how to repair front crankshaft seal leaks oil Need to get at the crankshaft seal, usually by removing the crankshaft pulley and using a seal remover to take out the old seal, then put a new seal in. ...

...the engine support bracket. Detach the engine support bracket and take off the torsional damper and crankshaft pulleys. This ensures easier access to the timing belt.3. Locate the 2- to 3-inch wide ...

...it died the oil light came on. Any Help Would be GREATLY APPRECIATED. TIA Ever since I changed the Crankshaft Sensor my check engine light has been on. When I check it it says multiple misfires. ...