Questions & Answers for: Honda 2 4 crankshaft

Ad

Question about 1992 Accord

2 Answers

honda accord ex 92 how do i change the harmonic balancer? Crankshaft pulley (harmonic balancer) removal- disconnect neg battery cable, remove belts, it would be a good idea to soak the bolt w/ ...

Ad

do i need to remove the crankshaft to change the front crankshaft seal You don't remove the crankshaft, but you do have to remove the timing belt. It's a rather major job.

Ad

how to replace Honda front Crankshaft Seal how to replace 95 Honda accord 2.2 front Crankshaft Seal Have to take off the crankshaft pulley to get at the Crankshaft Seal. Use a hooked seal remover to ...

...Gears Removal & Installation To Remove: NOTE: Keep the cam chain away from magnetic fields. Crankshaft set at TDC marks Turn the crankshaft pulley so its Top Dead Center (TDC) mark (1) lines ...

...Record anti-theft code for radio. Disconnect battery negative cable then positive cable. Turn crankshaft pulley until TDC is achieved. Raise and safely support vehicle. Remove front tire ...

...after the repair. If you can purchase a replacement connecting rod kit, you will have to take the crankshaft to an experienced engine rebuilder that has the equipment to press the crankshaft apart ...

Question about 1999 Accord

1 Answer

...check engine light just turned on and engine turned off. what could be the problem. P0336 Honda - Crankshaft Position Sensor 'A' Circuit Range/Performance Possible causes - Faulty crankshaft ...

Question about 1999 Accord

1 Answer

snapped crankshaft pulley bolt the serpentine belts came off while driving and the crankshaft bolt was loose,I took it all apart and put back together,now there is still play in the harmonic balancer.

where is the crankshaft positioning sensor on a 2000 Honda Accord VTEC 3.0 6 cylinder My info shows the crank sensor takes its reading from the front end of crankshaft. You will have to remove crank ...

location of camshaft position sensor on 98 Honda accord 2.3 The Crankshaft Position Sensor for the 2.3L 4-Cyl. engine is located behind the crankshaft pulley on the oil pump assembly. DTC P0335 How To

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

1992 Honda Accord
1992 Honda Accord

2,940 Questions

1991 Honda Accord
1991 Honda Accord

2,649 Questions

1995 Honda Accord
1995 Honda Accord

1,606 Questions

1996 Honda Accord
1996 Honda Accord

1,608 Questions

1998 Honda Accord
1998 Honda Accord

1,531 Questions

Top Honda Experts

Marvin
Marvin

Level 3 Expert

85206 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...