Questions & Answers for: Sharp 2830 motor unit

motor. Typically is it cheaper and easier to replace the Laser Unit. Sometimes Simulation 14 will clear this for a short time.. if it this code does not clear, a new laser unit is needed.. The Polygon

...motor unit abnormality Improper connection or disconnection the main motor and the harness. MCU PWB abnormality Check and remedy Use TC 25-01 to check the main motor operations. Check connection of ...

...motor overloaded 22 Paper feed unit without power 50 Paper feed unit not installed properly 51 LCT not installed properly U7 00 Main board malfunction U9 00 Op panel problem 90 Op panel problem EE EU ...

...motor overloaded 22 Paper feed unit without power 50 Paper feed unit not installed properly 51 LCT not installed properly U7 00 Main board malfunction U9 00 Op panel problem 90 Op panel problem ...

HAVE PROBLEM WITH SHARP AR-5316 IS COD-L6 10 this error is a Polygon motor lock. the polygon motor drives the mirror in the laser unit. You will have to replace the laser unit or the motor/mirror unit

it shows l6 This error is a Polygon motor lock. the polygon motor drives the mirror in the laser unit. You will have to replace the laser unit or the motor/mirror unit.

...motor unit failure Polygon motor connection harness trouble or disconnection MCU PWB failure Check and remedy Check the polygon motor operation with SIM 61-1. Check connector/harness of ...

mx 2830 - fails to print - asks to add extra plain paper My Sharp MX 2830 is asking me to add extra plain paper every time I try to print from my pc. Other people print normally to it. This is the ...

...because its showing error code l4 even after i replaced the main motor check connection of main motor , check maindrive , check resistance of developer unit / fuser unit / opc- unit replace worn ...

...Main motor lock, Main-motor is unable to turn or has too much resistance, mlean main drive , and replace worn gears , if problem persists , check resistance on fuser-unit / developer-unit / ...