...22*C my jimmy stalls and I have to wait like 5 or 10 minutes to start back up again, and when its really hot outside it jerks and stalls all the time...what could be the issue...I am told that I have ...
...10) Note : 12 and 11 are at the vey front of the vehicle: the torque sequence is as follows step 1) torque all bolts to 22 foot pounds step 2) turn bolts as follows short bolts an additional 55 ...
...it causing rough idle. Need 10mm wrech and socket set. I found the part at napa for around 22 bucks. I have had my 93 4x4 Jimmy for 10 yrs it now has 235000 on it and still going. your timing is ...
opens it get caught in there. i have cleaned mine several times and finally found the gasket at napa for around 22 bucks. All you need it 10mm wrech and 10mm socket with ext. takes around 10 min to do
...10) 1st pass: in sequence to 22 ft. lbs. (30 Nm). M11 bolts (1-10) 2nd pass: in sequence + 90 degrees. M11 bolts (1-10): + 70 degrees. M8 cylinder head bolts (11,12,13,14,15) to 22 ft. lbs. (30 Nm). ...
...10 what now none of the front ,back ,or break lights work. check flasher fuse #14, ign E fuse #22, and stoplamp fuse, if all this ok see the problem at turn signal/hazard flasher module located at ...
Question about 1999 Yukon Denali
...10 3 1 5 9exhaust side 7 6 2 4 8Step 1all 11mm bolts 22 ft lbsStep 2all 11mm bolts turn add 90degStep 311mm bolts 1-8 turn add 90 deg11mm bolts 9 and 10 turn add 50degStep 4all 8mm bolts 22 ft ...
Question about 2003 Yukon Denali
...10) to 50 degrees a final pass in sequence Tighten the M8 cylinder head bolts (11, 12, 13, 14, 15) to 30 N·m (22 lb ft). Begin with the center bolt (11) and alternating side-to-side, work outward ...
Question about 2000 Sierra
...22, 2006 - 13 posts - ?10 authors I was driving down the freeway today and got a "low coolant" message. As you can ...Bob 2000 Ext cab Silverado 4x4 w/ 5.3. Back to top ... 2002 Silverado Battery ...
Question about 2000 Sierra
22 lb ft). Use a torque angle meter in order to tighten the cylinder head bolts in sequence on the final pass. Tighten: Tighten the long bolts (1, 2, 5, 6, 9, 10, and 13) on the final pass in sequence
Usually answered in minutes!
2,225 Questions
1,363 Questions
1,368 Questions
1,418 Questions
1,123 Questions