Questions & Answers for: JVC 220

Rear Projection I have experienced that and I found out that it was plugged to 110 volts instead of 220 volts. Becaouse I bought mine in the Philippines,it is 220 volts

...screen, without luck. i tested all the resistors, and the only two that dont seem right are the 220 ohm on the r873 spot on the board, and the 150 ohm resistor on the r863 spot. both read 89ohms ...

...if still nothing then the power supply board needs servicing. This repair shouldn't cost more than $220 if the power board is bad but prices differ from State to State.... Let me know if you have any ...

could jvcrx 778 be converted from 110 VAC to 220VAC power input ? or is it an auto volt if it says 110/220 on the bk and there isnt a switch to change to 220 its auto but if it doesnt say 220 on there

How to set clock? JVC KD-G 220 Hold down the select button on the radio. You will see clock (Hours) use the volume knob to adjust. to get to (Minutes) hit the track buttons.

where is my remote wire input on my jvc g-220 remote wire Remote wire is for power antena or any other ancilliary unit is the blue with white stripe. You can find the installation manual on the jvc ...

how do I set the time on the JVC KD-G 220 cd player JVC model KD-G 220 Press and hold SEL Press UP to select [CLOCK H] When Clock H is shown, rotate volume knob to adjust Perform same steps for [CLOCK

...power voltage that stands at 110v here in the States, will this unit work in a place that runs on a 220-240 voltage country without using any adapter? No. To work with 220V~240v; the device need a ...

I have a JVC ax 220 amplifier and there is no sound coming out at all. No sound at all. Is the receiver even turning on? If it is, listening carefully to the top cover, with the room quiet. Do you ...

I need schematic diagram for my JVC DVD cassette receiver Model No. CA-DXU 10 AC 110/127/220/230-240 ac 50/60Hz 300W My JVC transformer got burnt, after rewinding works, the digital display did not ...