Questions & Answers for: kawasaki 20 125

...of the problem.you can it get it done by an aluminum welder for cheap. friend had it done for like 20 bucks at a local car shop with an experienced aluminum welder. seems like thatw s a deal as i

bike runs for 20 seconds then dies an wont start again pull spark plug out and itis soaking with gas Change The Spark Plug hi mate sounds like your flooding the crank case with fuel try a NGK BR9ES ...

How much oil does it take for an oil change. Oil How much oil does a 2004 Kawasake KLX125 need for an oil change? Oil Weight (10w40 ...) ? 4t 10w40 With a filter change it takes 950mL or oil, and ...

WHAT IS THE CORRECT FUEL TO 2 STROKE OIL RATIO FOR A 2006 KAWASAKI KX85 It all depends on what type (and brand) of two stroke oil you're using. For example, some non-synthetic two stroke oils are ...

03 klx 125 after riding for 15-20 min. boggs and wont't go but idles ok Check oil level

torque spec on kaw. kx60 cylinder head bolt set it between 18 and 20 lbs do this on cold settings

...125 I just bought used which takes 20-30 kicks with the choke on to start and if it is cold outside even more. Then the choke has to stay on for a minute until the motor gets warm or it won't run ...

...125 and takes 20-30 kicks to start with choke on and even more when cold. Won't run right until motor warms up n takes a while for it to warm up. Runs fine after it does but it's hard to get started. ...

...20. A stuck bent or burnt valve. 21. Tilt sensor needs a reset. 22. Security system not disarming alarm needs a reset. 23. Check for engine trouble codes. For more information about your issue and ...

...lots of $$$$. If you do it yourself it's a great project. Buy a service manual from say amazon for $20-25 bucks and get to wrok. good ...