2005 nissan altima Its right next to the passenger side drive shaft, where it goes into the transmission. Right above the drive shaft. It s black with green slider inside of the connector and it has 3
...2005 Nissan Altima loss power while I was driving down the street, the next day it cut off at a light, it takes a few seconds to start, but always starts the 2.5 altima's had a recall on that problem ...
...2005 nissan altima 2.5 S engine get off My 2005 nissan altima 2.5 S engine get off sometimes while we are driving. we have to wait some time, it gets colder and we can resume driving. sometimes the ...
where is the crank shaft sensor located on the 2005 altima 2.5s automatic The crankshaft position sensor is on the right rear of cylinder block, below starter motor.
...2005 nissan altima. car jerks on freeway and engine shuts off. Already replaced the crankshaft sensor. what can the problem be It sounds like your Mass Air Flow Sensor is faulty. These sensors will ...
2005 Nissan Altima, Car keeps stalling and is jerking while driving. Check engine light says crankshaft position sensor, but I changed it and it's still doing it. 2005??? dealer only encrypted ...
real hard to start, replaced the crank sensor still getting trouble code po335. 2005 nissan altima, 2.5l crankshaft sensor circuit A broken wire
What has to be removed from the engine before you can access the crankshaft positioning sensor on a 2005 Nissan Altima? nothing in most cases
Question about 2005 Altima
...2005 altima also the o2 seneor car still will not run. error code 335 What else could be the problem? DTC P0335 - Crankshaft Position Sensor A Circuit Malfunction The crankshaft position sensor (CKP) ...
...altima-2005 > recalls CERTAIN TYC HALOGEN TYPE HEADLAMP ASSEMBLIES P/N 20-6644-00 SOLD AS AFTERMARKET EQUIPMENT FOR 2005-2006 NISSAN ALTIMA ... 2005 Nissan Altima Safety Recalls - Autoblog ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions
