Questions & Answers for: 2000 jeep cherokee headlamp assembly

...2000 Jeep Cherokee Larado). 1) The cause of the problem is heat from the bulb. 2) Remove the light assembly as if you were going to change a bulb. 3) Turn the socket and remove it from the taillight ...

...2000 Grand Cherokee. The engine fan won't come on. The fan works when jumped to the battery. The 40 amp "fuse" in the fuse box is good. There is power at the fuse box. I'm assuming a sensor or relay ...

...jeep cherokee It lives under the right headlamp assembly. You can remove the front fascia and headlamp bracket to gain access, or you can just remove the right headlamp and use a hole saw to drill a ...

...2000 Jeep Grand Cherokee is turned off (no key in the ignition), the headlights will occasionally turn on by themself. They turn off after a few seconds. Is my Jeep haunted?? Usualy a faulty headlamp ...

...headlamp assembly and bracket. You can remove the front fascia, both headlamps and the bracket (the bracket runs all the way across) to gain access. Or you can remove the right headlamp and use a 1 ...

cherokee, I know that is located under the passenger side headlight, what parte I can remove to replace them. You will need to remove the passenger side headlamp assembly. Once it is out you can drill

this is the sign of a failed fan relay. The cooling fan relay is located under the right headlamp assembly. The sending units for the cooling system are generally located in the bottom of the radiator

...then you may want to check your fuses and relay for the cooling fan. In the case with this Jeep I worked on, it was the Cooling fan relay; located under the right headlamp assembly. I hope this ...

...2000 jeep grand cherokee, coolant was leaking, pressure tests done, radiator cap replaced, new radiator put in, new water pump put in, all this time I keep putting coolant in, at first it was every 3 ...

...2000 Jeep Grand Cherokee. If you have the manual for it, the instructions are in there. Open the hood, disconnect the negative battery cable, remove the two screws on the top of the headlight and ...