Questions & Answers for: 2000 ford mustang battery light

2000 v6 mustang. #3 relay? The wipers will not work on my 2000 mustang. I checked the fuse and i wasnt blown. My 2001 V6 mustang had the same problem. One day the power locks, interior dome lights and

Ad

...Ford Mustang and the battery is being drained by something while the engine is off. We disconected the security system, so we know that is not the problem. We also checked the battery and its good. ...

Ad

...2000 Mustang 6 cylinder We just had a tune up and replaced the coil pack. Everything is running fine but the check engine light is still on. Is there a way to reset this? Unplug the battery for 15 ...

Question about 2006 Mustang

1 Answer

...Mustang Battery light comes on for a few seconds then goes out no codes at all, regulator puts out 14.3 to 14.6 at 600 rpm or 2000 rpm when you turn on all lights,ac,fog, radio it drops two to three ...

Question about 2000 Mustang

1 Answer

...2000 Ford Mustang GT convertible and when I started it up this morning, it had the warning light thats yellow with an "x" in it....it has a brand new battery from the dealer and they said ...

2000 ford mustang electrical problems car will not start, have no lights, no radio, nothing. just replaced the ignition switch hoping this was the problem. Battery, starter, & altenator all tested

2000 ford mustang 6 cylinder stalls sometimes and wont drive till the next day then it runs perfect again it happened last week then again this week it stalls and the battery light stats blinking the ...

... 1998 ford mustang get a test light and disconnect the negative battery cable hook test to neg bat post open fuse box and start checking fuses if the light lights up on a fuse that might be the ...

2000 ford mustang gt Turn on key and no power, no 2000 ford mustang gt Turn on key and no power, no dash lights no headlights no horn truck switch or remote doesn't work put 12 volt tester on + ...

2000 mustang gt has hot battery, but nothing works, no horn, headlights, dash, remote won't work correctly. Put a 12 volt tester on the positive cable and ground to the engine and the tester lights up

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...