...Ford heatimng systems except the Focus. If the front heat doesn't work, but the rear does, it's most likely one of two problems: (1) the front "blend door" is broken, and not changing position when ...
where is the blend door actuator in a 2000 ford focus look behind the glove box area to the left square motor
Question about 2000 Focus
...controls all the doors on it go to http://www.alldatadiy.com and buy a subscrption there for your car they will have all the parts location for you there, most likely the blend door vac. motor is
...ford focus diezel year 2000 does your blower motor work or it just blowing cold air? if it does not blow then check the fuse, the motor may be bad if it blows cold air only then check your coolant ...
...blend door. Probably your resistor block usually down under the glove compartment area. Controls the heater current draw.One screw holds it. don-ohio If the control module was just changed, check for ...
...Blend Door Failure In all modern cars there is a tiny DC electric motor driven gear drive that moves a plastic door that blends heated and cooled air from the AC and the heater core, this is called ...
no hot air but thermostat and heater core are new sounds like the blend door motor
Question about 2000 Focus
...ford focus 2000-2.0-dohc suddenly stopped.. would it be an air condtioner fuse blown? Test low pressure switch using jumper wire if you think it has enough freon. Low pressure switch may have failed. ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions