Questions & Answers for: 2000 chrysler town country start

Ad

Question about 2000 Town & Country

1 Answer

...2000 town and country 1. Starter wont engage 2. will start and run if I remove switch and the electrical switch and turn the the ignition block with screwdriver 3 Had locksmith clean the key switch ...

Ad

Question about 2000 Town & Country

1 Answer

...2000 town & country just started acting up. Had a tune up done & water pump changed. It still has trouble starting when it is cold. You have to pump gas to get it to start now & also when ...

Ad

...there was no smoke or sound. the car seems to be running fine. 2001 chrysler town and country. I am going to guess that the sound and smoke were from a stalled belt. Check your belt for a burned

...town and country 94 3.8 it wont start. Acts like a lean condition. Pops by the intake. I crank it it turns but it wont stay running. new O2, checked TPS good. what else should I check? VACUUM LEAK AT ...

Question about 2000 Town & Country

1 Answer

...Chrysler town and country it want start my husband had my battery and they said it's ok this is my only transportation please help OK, you had the battery checked out, it is OK, does the engine crank ...

2000 chrysler town and country i half to hold the gas pedal down for it to start and the cadlac converter turns bright red whats it problem your either running exstremly lean or its clogged up .(catt.

2000 Chrysler Town and Country: Fuel Gague reads 3/4 yet runs out of gas and dies. Upon refueling, (1 gallon) it will start and run fine though quits again at 3/4 tank. This problem began happening at

Question about 2000 Town & Country

1 Answer

2000 town and country trouble starting. sometimes is starts on the first try, other times it takes several tries and it will click once, then nothing. we cleaned the battery terminals and actually ...

van slipped out and back in gear, started to run rough, and all guages went blank will not start just makes clicking noise. FUEL PUMP

Question about 2000 Town & Country

1 Answer

the engine is running about 3500 RPM I removed the intake to replace spark plugs and valve cover gaskets. The van was running OK before I started work. After reassembling when I start the van the RPM ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

Marvin
Marvin

Level 3 Expert

85178 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

john h

Level 3 Expert

22406 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...