...was a mild smell from the set. Burnt small 2KV capacitor near flyback xformer....original is 221K....I use 271K / 2KV ...Possible burnt 1K 1/2 watt resistor and shorted zener diode ....ECG
Jim Shorted cap Location # 3213 = .01 / 3KV Shorted diode # X3204 = NTE 519 Burnt resistor R2925 = 1K 1/2 watt Flyback usually ok..................................................T
...problem? 1) bad solder connects 2) Diode X3204 leaky = replace with NTE 519 3) R2925 burnt = W10 = 1K 1/2 watt 4) Location 3213 capacitor change = .01 / 3KV These suggestions are to assist a ...
Question about R40W46 40" Rear Projection HDTV-Ready Television
zenith red convergence problem. I read the previous post regarding the the red convergence arc. I did find 2 resistors that look discolored. I am not sure if I am at the right board. I have 4 wires ...
Question about R40W46 40" Rear Projection HDTV-Ready Television
Question regarding convergence resistors I'm having the blue convergence problem exactly as desrcibed in this forum and have purchased new IC's. I also purchased a pack of 3.9 ohm 2 watt flameproof 5%
Question about R56W36 56" Rear Projection Television
r56w36 zenith projection television crt hi, i have found a resistor with no reading at all.this is bad? also all the rest were good.i only tested large resistors,do i need to test all the little tiny ...
Question about R45W46 45" Rear Projection Television
R2728 and R2734 Resistor values and part#'s I have a Zenith R57W46 tv that has these two resistors burned out. They look to be the same value but they look pretty burned so I cannot tell what the ...
Question about R60V26 60" Rear Projection Television
Zenith R60v26 has burnt resistor at RK5 on convergence board I have a Zenith R60v26 with a convergence problem. so I replaced the IC's and now the problem isn't as bad. the red and green seem to have ...
Question about R40W46 40" Rear Projection HDTV-Ready Television
convergence chips and resistors hi i own a zenith projection tv the model number is r40w46f we are attempting to change the convergence chips and resistors on our tv as we have been having problems ...
how do i no if my resistors on my convergence bored are bad. is there a way of testing each individual one and i hear something abought fuses. could this be my convergence problem i am having What ...
Usually answered in minutes!
269 Questions
273 Questions
232 Questions
195 Questions
159 Questions