air and heat wont work unless blower is on high, where do i find the regulator to change it Sound like the blower motor resistor is bad. Blower Motor Control Module Removal & Installation To ...
...many things. But a simple solution could just be an idle adjustment. Typically idleing should be at 1k/rpm or above, if your idle is lower then 1k/rpm it can cause engins to stall. To adjust is very ...
1k,) and an 800 ohm resistors to wire together in series to achieve the 11.801k ohm value. Here's an example of how you'd connect the above mentioned resistors in "series" wire------10k ohm------I----
Fan only works on high need to replace fan switch It isn't the switch it needs a new blower resistor and new fan motor. The fan motor will start to pull too many amps through the resistor and in turn ...
Blower motor won't work, even with new motor. Blower motor was loud and sounded bad, it quit working yesterday. Installed new motor still nothing. Check restitor with meter and it is still good (a ...
Need to find heater blower resistor on 1991 Buick Park Avenue GM: Electra/Park Avenue/Ninety-Eight 1990-1993 REpair Guide Blower Resistor Module Fig. 1 Blower resistor assembly is underneath the fuse ...
Question about 1992 Park Avenue
92 Buick Park Ave with blower control module problems where is it located? Where is it located and how do I remove it? 1993Blower Resistor ModuleREMOVAL & INSTALLATION Print Fig. Fig. 1 Blower ...
buick skylark problems The car is stalling every few minutes, spent over 1k so far, electical checked out, fuel pump replaced, what can we do? ECU Issue
location resistor 2005 buick century resistor ??? What resistor ? HVAC blower motor resistor ?
Question about 1989 Skylark
I have the panel down, below the glove box down, but cannot locate the resistor, I see the fan, but not the resistor on my 2005 Buick Century. Does the vehicle have manual or automatic climate control
Usually answered in minutes!
1,731 Questions
1,603 Questions
1,084 Questions
1,091 Questions
904 Questions