Questions & Answers for: Mazda 1999 starter

starter i have a 1999 mazda 62 2.0 liter 4 cylinder dohc and the it is starting slow i think the starter is going out how much do they run for and how hard is it to change out. You can get the starter

1999 626 2L. replaced starter with a rebuild. Solenoid still hung up. Rebuilder does not use a new solenoid " refurbishes" them. Advised to get a remote ice cube relay to place in the circuit, says it

...1999 mazda 626 but now the motor has no power to the starter. I put the key in and it chimes the door locks work the lights and break lights work the horn works the trunk lock works. but thats it ...

...starter motor out of the car to the floor? I have a 1999 Mazda mpv v6 I'm assuming 2wd. Disconnect the negative battery terminal. Jack the passenger side and place on a safety stand. Starter bolts (2 ...

1999 mazda 626, 4cyl. Car will not restart after running. If the car sits for several minutes (~15-30) the car will restart and run fine. Sounds like a possible starter problem if the starter will not

...the relay to click, or starter solenoid to act ... My 1999 b2500 just stop working while drive about 50 M/hr when i tried to restart, the engine just turns over but will not start. what can I

1999 mazda protoge will not turn over. Battery is good. Was wrecked by hitting a deer 9 months ago. Could it be the starter jammed? First thought it was fuel shut off but i read this car does not have

...1999 Mazda 626 4cyl I have replaced the battery and had the starter check it will crank but not start i have even sprayed starter fluid in the injection system and it still just cranks.. please HELP ...

...1999 cant find starter motor on mazda 323 1.3 1999 Hi Cliff, Locate positive + battery cable,trace its path,it should lead you to starter solenoid connection.starter motor will be at engine to ...

...1999 mazda demio, the engine starts, and the starter motor keeps running, any help please this happens on second click of the ignition Bad bendix or starter installed without correct shims. Check for ...