1996 LEXUS ES300 3.0L Need to see how the vacum lines are connected to the Intake manifold. They were removed when replacing the Valve cover gaskets. Thank you, Arthur i have prolem with my car p0753
...valve seals, this accounts for the smoke on start up My Lexus is doing the same thing. I had it diagnosed and I was told oil is leaking from the valve cover. The valve gasket needs to be replaced. ...
Valve cover and Oil pan bolt torque I'm replacing oil pan gasket and valve cover gasket, looking for torque on bolts for both. Also any series of tightening order if there is one. Inside to outside ...
...lexus es 300. This procedure is similar to a 93 Camry with V6 engine...It's a pain in the...! Essetially, you have to remove the intake air plenum to gain access to the firewall side of the engine ...
1997 lexus will not stay idle 1997 lexus es300 won't stay idle when i start the car. most likly is the air idle controll valve.needs replaced.
...located on a 1992 lexus es 300 there are 6. 3 are located in front valve cover and 3 are located under upper air intake in the rear valve cover.they can be removed without removing the upper
valve cover gasket leak on 95 lexus es300. how do i fix Take the valve cover bolts off then get the new gasket on or use permatex gasket glue than put it back together
...valve cover, front of engine remove the plastic cover with lexus logo using hex 5mm key 2 bolts , unplug 3 spark plug wires ,loose all 10mm bolts on valve cover , to rear engine valve cover remove ...
repair manual for Lexus ES 300 need a diagram for the replacement of heads and valves the settings and torque ratioi.
oil on spark plug Most likely your valve cover gaskets and the spark plug gaskets need to be replaced.. when they are old they start to deteriorate and allow oil in the spark plug.
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions