Questions & Answers for: 1996 jeep grand cherokee modulator

1996 jeep grand cheerokee laredo,wont start. i have fuel pressure oil pressure, and spark,i changed the fuel filter,ignition module,then i checked my rotor cap it was all melted inside so i replaced ...

...Jeep to Autozone to reset the check engine light after replacing the idler pulley and power steering pump pulley and the autozone tech said that all eight of my cylinders are misfiring. What could be ...

...grand cherokee will die randomly or wont start up that day, but will run just fine the next. I have already replaced the feul pump and filter, what else could be the problem? it could be a bad pickup ...

Cold it will shift in to gear, but when it worms up will not go in to any gear When it’s cold the transmission will go in to all the gears, when driving it will not go in to overdrive cold or worm. ...

...1996. 11 No ignition reference signal detected during cranking OR timing belt skipped one or more teeth; OR loss of either camshaft or crankshaft position sensor. 12 Battery or computer recently ...

...jeep is staying in a high gear and wont SHIFT down or go into over drive! what could be causeing it do do that I think that the modulator valve has failed. It isn't a tough fix. Get a new one and ...

...valve pressure monitor and remounting and balancing the wheel. You must also recalibrate the system.. ( In you car Manuel). Each monitor runs about 25-50bucks.. You can find them sometimes on ...

...jeep set for over 2 hours it is extremely hard to start. That could be caused by a few different thing's . One would be a fuel pump static pressure check valve ,located in the fuel pump module . The ...

1996 Jeep Grand Cherokee not to start P0006 is a generic OBD-II code indicating an issue with the engine control module (ECM) not receiving correct signals from your fuel shut-off valve. ... The Check