Questions & Answers for: 1988 dodge power coil

...power to coil with key turned on but loose power when i try cranking motor giving me no fire to start Sounds like a bad ignition switch It when the switch is in crank mode it should supply power to ...

...dodge ram 50 will not fire we have replaced the coil and i need a diagram for the wiring. there are 4 wires that go to the coil does anyone know the ordrer they go in? Or have any idea of something i ...

...1988 Dodge Daytona 2.2 turbo(non-intercooled). Starts but shuts down after a couple minutes as if power was killed. Only code showing is 23(charge temp sensor circuit). ASD relay, coil, timing, all ...

...dodge dakota, draining power, relay switch, coil... started having issues running iwth lights on. would die as driving. found no power to coil bypassed and started running. Changed A relay just not ...

power to coil through several relays on my 1988 ramcharger the relays on the drivers fender send power to coil, distributor , and fuel pump use a test light with ignition key on to find which is which

...1988 dodge daytona 2.2l turbo w/o intercooler, 5 speed manual. car ran fine, then started to over heat, shut off on a me a few times-just died. then would start back up and go a bit more, then just ...

...dodge dakota truck with a 3.9L. there is no fire going to the coil. i have replaced the module and the coil. still won't start. I get code 34 please help me to diagnose this problem. thanks Replace ...

...1988 Dodge Ramcharger 1988 dodge ramcharger 5.2 liter. no fire or fuel.replaced computer and coil still no fire or fuel.jumped 12volts from battery to coil and will fire but still no fuel. removed ...

...1988 Dodge Ram didn't have a distributer cap or 12 volt coil when I got it. I need to know how to put it on The distributor cap will only go on one way due to an alignment slot and the coil is hooked ...

...1988 dodge pu. Ram no fire to plugs. Replaced coil still the same. Check to see if getting power to coil. I had a similar problem and the crankshaft sensor wasn't sending signal, no signal no fire. ...