Questions & Answers for: 1966 mustang starts run

mustang 1966 ignition problem. Ignition switch when turned on all lights ok.Turn to second notch and something runs to earth.Will not start.With ignition switch on i ran a seperate earth lead from the

68 mustang cant drive the car for 2 blocks. it loses to much water.no leaks no steam no broken hoses. and the car isnt running hot. wont start if turned off needs to be jump started The water has to ...

mustang with 1966 289 c. code .engine starts good .idels ,good till it reaches running temp. then it sounds like the rockers start to chatter .and mis fires till it dies.it has 40psi on oil gage while

1966 Mustang. Driving in 90-100 degree heat. Starts great when engine is cold, but when it gets hot, car will die instantly (no warning, just shuts off). Usually starts right back up, but sometimes ...

1966 Mustang I6 starting problem 1966 Mustang I6 cranks and fires if i use starter fluid in the air intake, but stops running after a couple of seconds. Sounds like the fuel pump, clogged fuel filter,

have a 1966 ford mustang. the car running very rough once i get it started.after a few seconds the car then stalls out Sounds like: Timing (180 out) Vacuum leak

1966 Ford Mustang and the battery was totally dead. I jumped it and it started. After running the car for about five minutes, I tried to restart and it barely cranked. The battery is almost brand new.

...1966 Mustang. 200 six cyl, auto. PROBLEM will not start no spark, replaced coil, ign switch, voltage regulator, plug wires, dist cap, electronic ign. still no spark Help. drove her 2 weeks ago run ...

1966 mustang 289. won't start, jumped across solenoid, started. Replaced solenoid-starter wouldn't disengage, replaced starter, back to square 1, jumping across solenoid to start - whats my ...

...1966 Mustang convertible starts if jumped but not without. When turning the key it simply makes a clicking noise. Help! Check the battery voltage, it should be 13.5V if it's fully charged. Charge it ...