...13: Tighten the intake manifold fasteners to 78 inch lbs. Step 14: Tighten the intake manifold fasteners to 70-84 inch lbs. ④ 10-12 ft. lbs. +60-65 degrees ⑤ Step 1: 72 ft. lbs. ...
...70-80 degrees clockwise with the wrench, then tighten the locknut. Turn the crankshaft in a clockwise direction several times, then slowly set the No. 1 piston to TDC of the compression stroke. Apply ...
...13-16 ft. lbs. (18-22 Nm).Before tightening, be sure to set the camshaft lobe at the position where the lobe is not lifted. Install the upper and lower timing belt covers. 1988 Engines: While keeping ...
...13: Head bolt torquing sequence-1970-83 models After repair job, temporarily install and tighten the two center (right and left) cylinder head bolts to 14 ft. lbs. (18 Nm). Install the camshaft ...
...so 185/70/13 195/65/14 205/55/http://www.importtire.com/itphotos/doc-od-ref.pdf15 this link gives rolling radius of tyre sizes you want to match original as near as possibble give or take a few ...
Question about 2002 Sentra
...70% of the width 13 is wheel size in inches radius(amount of distance travelled to turn once) 23.23 for 185/70 22.68 for 175/70 so with 175/70 your speedometer will read slightly more than it ...
Usually answered in minutes!
1,587 Questions
1,450 Questions
1,309 Questions
1,122 Questions
1,306 Questions