Ford engine doesn't start after self tune up I have a similar problem with that recently by working on my Ford F150 5.0 efi by installing the works on tune up. I replaced the spark plug, spark plug ...
Rough running and timing jumps all over the place With a timing light on, at idle the timing jumps between 10 degrees BTDC to 15 degree ATDC. Thinking its an ECM, any ideas? I'm sure someone has a ...
what is the timing degree on a 1992 ranger 3.0 motor 10 degrees BTDC. :-)
when setting the ignition timing on a 1991 ford ranger 3.0 were dose the rotor need to point, after number one or before number one? the engine is on top dead center The engine timing markers down on ...
...has been changed, the heater core is flowing free, the coolant is fine. The lower radiator hose continues to stay cold. The upper heater hoses stay between 130 - 135 degrees. it could be the ...
I did find the low port (on the cylindrical part) I hooked up the pressure gauge and found it to be 130 psi whereas I expected it to be very low. Something very wrong here so I quit and am now seeking
...replaced heads and head gaskets ,I now have a knocking noise and #3 cylinder plug is burning black ,130 compression on all cylinders ,any imput would help Spark plug wires crosses or timing is too ...
Timming specs for94 ranger at what degree do you set timming? Hey S. Arnold, 1) 4cyl 2.3L is 10 deg. 2) 6cyl 3.0 =10 Degrees Special procedures are required for proper adjustments refer to emissions ...
head bolts torque settings head bolt torque settings for 3.0crd 2010 model 1st 36-39 ft-lbs, 2nd loosen one turn, 3rd 20-24 ft-lbs, 4th turn 85-95 degrees, 5th turn 85-95 degrees
Question about 2000 Ranger SuperCab
00 ford ranger xlt 4x4 manual Rod bearing bolt torque specs It's the 3.0l v6. The rod bearing cap bolt torque specifications for the 3.0L V6 engine in a 2000 Ford Ranger XLT 4x4 with a manual ...
Usually answered in minutes!
642 Questions
645 Questions
573 Questions
562 Questions
558 Questions