1997 ford escort 2.0 head bolt torque setting and order can you possible tell me this Thanks jim usually it is 45 ft/lb then turn each one 90 degrees and then 90 degrees again
hi i need the torque setting for ford escort p reg cylinder head and cam bearing can you help hi the cylinderhead torque settings are STAGE 1, 30Nm (22l bf ft) STAGE 2, 50Nm ( 337 lb ft ), STAGE 3, ...
Question about 1998 Escort
what is the torque on for the rear wheel hub of the S reg escort does any one know what the torque is for the rear wheel hub of the S reg escort 130 to 174 ft-lbs
TRANSMISSION WILL NOT SHIFT AT ABOUT 5AM WHEN I GO TO WORK MY CAR WILL ONLY SHIFT TO DRIVE. WHEN THE WEATHER DROPS BELOW 70 DEGREE MY CAR WILL ONLY GO INTO DRIVE. TWO TIMES IN THE LAST TWO WEEKS I WAS
My car was frozen ( below 32 degree) for two weeks. I pulled it into the garage and let it sit. It's about 45 degrees in the garage. The engine turns over, there is fuel getting to the cylinders and I
1998 Escort: WHAT TYPE OIL GOES IN A 98 FORD ESCORT... What type oil goes in A 98 ford escort a car with over 75k requires a slightly heavier oil so i would reccommend using 20/50,best you can afford.
need torque specs for 1994 ford escort 1.9 ltr head bolts Torque new cylinder head bolts in sequence to 44 ft lb. Loosen bolts approximately two turns, then torque bolts in sequence to 44 ft lb. Turn ...
...for the baro. the maf produces baro info. if the maf is bad, ussually dirty, the baro will read low 130-148 herz. if its above 150 and your 1000 ft above sea level its probably ok. if you have any ...
Hi, my 2005 tdci 130 bhp mondeo has recently started making a rattling noise at 73,000 miles when I push the clutch in. Having said this it is selecting every gear perfectly and once I accelerate it ...
...Hello jenniebean12 The front axle nut torque is 174-235 ft. lbs. The rear axle nut torque is 130-174 ft. lbs. I hope this helps. Regards, ...
Usually answered in minutes!
2,142 Questions
1,335 Questions
1,118 Questions
957 Questions
841 Questions