Questions & Answers for: Rheem 130 degrees

reads nothing that heating element is bad and needs replacing. On each heating element is a thermostat to set the temperature. Set the upper element to 120 degrees and the lower element to 130 degrees

degrees on your water heater, you start creating scalding problems. 130 degree water can cause second degree burns in 30 seconds 140 degree water can cause second degree and even third degree burns in

130 degrees. once heater has warmed up it will restart for 3 sec and flame will go out and refire after 3 sec and go out and disply code C2-11 . third burner does not fire. after cool down heater will

130 degrees, maximum. However, there should be above the thermostat a red button. This is where the power wires connect to the thermostats and heating elements. Sometimes this button needs to be reset

...degrees. Start with the lower dial, this is your thermostat, Raise temp setting by 10 deg. Hypothetically, depending on what your present setting is, try setting lower thermostat at 130 and upper at ...

...60 degrees C is 140 degrees F. You can get burned pretty quick at 140 F. I suggest 125-130 F and see if that works First aid for burns is to apply cool water

...130 degrees. Is there something else I need to do. There is a upper thermostat with a scale of low to high, not sure what this is for. You have marathon water heater? Thermostat is probably bad. Has ...

...130 degrees. Have had problems with water being too hot then not hot enough over the last two years. Heater has been in service since early 2009. Using well water--has some minerals but not all that ...

...degrees is optimum for my household, but I live alone. If you have a family you may want to go a bit higher, 130-140. Also if it is electric get a water softener. It will save you time, money, sweat, ...