Trouble with speed. I have 1994 CR 125 and it has very low top and speed when I bought the 125 I noticed that it had 250 fatty pipe on it can that cause slow take off? Yes. The application of a proper
Bike won't start. Why a 1995 CR-125R won't start after adding fuel to an empty tank? Put your petrol tap onto prime
bike stall my cr 125 keeps stalling on me what should I do?Check the fuel tank petcock position. Check that the valve is in the proper position for fuel to flow. It happens. It's possible that the ...
motor just bought a CR 125 and the engine was full of water and the radiator was empty. Any sugestions? the evidence presented indicates that the head gasket probably was blown or head/cylinder ...
clutch lever hey when I ride my left hand gets exhausted becouse the lever is hard is there any setting to make it softer? my dad put some wd40 on it and its a soft as a babys bottom now try it before
twisted forks Today I was riding and i fell and i think i twisted or bent the forks. when the wheel is straight the forks/tripleclamps and bars face to the left and when the forks/bars/tripleclamps ...
tire Hey Everyone! Just wondering what tire pressures should be used for the different environments (Sand Medium Hard Pack). Thanks!In general you tyre pressure should vary between 12 - 16psi ...
chain i heard alot of way to adjust ur chain...does anyone know what ways realy work good.. Put it up on your stand lossen the axel and remove the bolt on the bottom of the shock. Then tighten your ...
tire what tire pressures should be used for the different environments (Sand Medium Hard Pack). In general you tyre pressure should vary between 12 - 16psi depending on ground condition's. The softer ...
Rear Axle Bolt on 2007 CR125R! What is the MM of that bolt.Thank you very much for your help.John Guessing i'm going to say between 18-20 MM.
Usually answered in minutes!
7 Questions
6 Questions
7 Questions
5 Questions
5 Questions