Questions & Answers for: Pontiac Fiero f 12

...to radio & in fuse panel, as there is usually 2 different wires for power. One has constant 12 v+, the other only when key is on, perhaps the one that is powered only when key is on, has

Ad

...the one has power and the other one doesnt, the other ones also not a ground. Be careful putting 12 volts to the injector harness,it will burn the e c m out.The module in the distributor,and the ...

Ad

...the right and left horns have different mountingbrackets. Install the horn and torque the bolt to 12 ft. lbs. (15 Nm). Horn RelayThe horn relay is located in the convenience center on the right

what is the 1987 pontiac fiero gt v6 check engine light code list? CODE 12- NO DISTRIBUTOR REFERENCE PULSES ECM. CODE 13- OXYGEN CIRCUIT. CODE 14- COOLANT SENSOR HIGH TEMP CODE 15- COOLANT SENSOR LOW ...

Question about 1987 Fiero

1 Answer

...runs untill it has reached it's normal temperature. when i check the fault codes , fault code 12 and 44 is on .. could this be a crankshaft sensor ???? or a broken fuel filter?? does the engine ...

Question about 1987 Fiero

1 Answer

87 fiero gt code 12 how do I fix it Code 12 doesn't need fixed. When you begin to test codes you will get the code 12 but that is just telling you that it is in diagnostic mode, it will flash the code

...console! The fuel pump is run by the ecm and the fuel pressure switch to check the fuel pump apply 12 volts to the aldl connector inside your center console. all you have to do is take the little ...

Question about 1986 Fiero

1 Answer

...air/fuel mixture to run too lean 10 check ignition timing ( too far retarded- should be around 10-12 degrees advanced) 11 check quality of fuel being used ( octane rating should be no less than 91 ...

Question about 1985 Fiero

2 Answers

...getting fuel The injectors need to be tested for pulses between the two wires (not to ground or +12) with the engine turning. With it still, you will get almost the same reading (only noticeable

...on the oil pan sealing flange. Install the oil pan and torque the 1 inch bolts to 6-9 ft. lbs. (8-12 Nm) and the 1.5 inch bolts to 14-22 ft. lbs. (19-29 Nm). Install the starter assembly. Install ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Manuals & User Guides

Loading...