...Chinese stuff, buy a cheap digital multimeter, specs are not important but make sure it has a 10 amp range (normally extra input for this). They can be had for under $20 US at any auto parts ...
...name brands at a 30%-40% discount off local prices, have used them many times over the last 10 years, they are very fast on
87 celica sitting for 10 yrs, will not start when gum out is added to the breather, the engine will run briefly. car sat for 10 yrs. Not getting fuel? Wondering what to check for and what to check ...
Question about 1991 MR2
... how many degrees befor dead center does the timing have to be set at? your timing should be set at 10 degrees with the TE1 and E1 pins jumped in the diagnostic connector located under the hood ...
...sub frame and pull it out. The other is to take out everything above the altinaor, and remove the 10 lb. bracket that holds it up and pull it out the top. Good
...system ( piping filter,and what not ) To be able to see it. It has 2 bolts and one nut Im sure. ( 10 mm. and or 14mm) It will come rite out! Its pretty easy to remove on this car.....unlike the ...
...light to carry enough current to start the car. Leave the jumpers hooked to the other car for about 10 minutes the try it again. Make sure you have good connections the other car should charge your ...
my 86 toyota mr2 over heats about 10 minutes into running it. the anti-freeze leaks out from around the head gasket but the oil and the anti-freeze isn't mixed together. i'm not sure if i should ...
...10" straps as a snake. You will have to introduce it through the drianage, and move it up and down until it gets unclogged. Use water as lubricant. Will take 10 minutes and willsave a lot of $$$$ and ...
My 1986 Toyota MR2 starts and runs perfiectly fine for about 10 mins when started up in the morning, but when it has heated up it instantly dies as soon as my foot leaves the gas pedal, I dont believe
Usually answered in minutes!
231 Questions
106 Questions
71 Questions
76 Questions
60 Questions
