It is suppose to rain tonight and tomorrow, should I refrain from using Round Up this evening?

Disable it for tonight work on it tomorrow or call repairman.

If the converter is restricted then there is no way to clean it other than taking it off and knocking all the catalyst out. Which is *******

best way to know is to remove the dipstick tube tonight and look at the color of the fluid-use a white paper towel and wipe it, and save it-tomorrow, do the same thing, using a different location on the same towel to wipe-if changed, the spot from tomorrow should be a bright red as opposed to todays, which will be a darker red (or even brown). You can also inspect the trans pan-it outside should be immaculate, since it was dropped and cleaned as part of the service. You can ask that they save the old filter for you to inspect, and even ask tomorrow if they cleaned the magnet in the trans pan-that is a basic thing that they should have done, and you should be able to judge what was done by their reactiion to this question. Continue to check the level (when fot) for the first few days, and put a piece of cardboard under it for a couple of days in case it leaks.

I have a 2003 4runner limited and the moonroof is jammed open.
I took it to the Toyota Dealer and they said they didn't know how to get it closed and charged me $44 just for driving it into the shop. Help it is suppose to rain tomorrow.

one of the biggest problem these cars have is the mass air flow sensor. if your mil light is on have someone scan your vehicle if there are lean codes or rich codes change mass air flow sensor . the maf is one of the biggest ecm inputs for the tranny.

if ALL the windows won't work that's either a bad fuselink (Short special wire designed to melt) or the switch is bad

Emergency, get a cheap tarpaulin from wally world and cover the cab, don't forget wind, use some weights or carpenter's clamps and you're good for tonight

tomorrow to the dealership you go

Crank should be in the trunk right with the jack to jack up the car

I believe the pump setting is 6.0 for the 155 BTU model. I will know more after tonight, we are using a Reddy Heater 155 unit tonight at church. I will look on the side panel and see what the PSI should be for the pump pressure and respond either tonight or tomorrow.