How do you reset a quicksilver moondak watch?

To reset your Timex 637 T5G951 WR 30 heart monitor, you can follow these steps:

1. Press and hold the "Mode" button on the front of the watch for three seconds until the watch display shows "Settings."
2. Press the "Next" button on the side of the watch to scroll through the settings menu until you reach "Reset."
3. Press the "Mode" button to select "Reset." The display will show "Yes" and "No."
4. Use the "Next" button to scroll to "Yes," and then press the "Mode" button to confirm.
5. The watch will reset and return to the time display.

Note: Resetting your Timex 637 T5G951 WR 30 heart monitor will erase all your saved data and settings, so you will need to set it up again after the reset. If you need to keep your data, consider transferring it to another device before resetting the watch.

You will need to pull out adjuster and turn to
right or left depending on the date you have on it.
Today 11th so if on 1st turn clockwise until you get
to 11th.
LUCK

you will need to press the reset or a/c button located usually near the battery well with a pin and a magnifying glass

I would think it is the sensor circuit in the watch. When you replaced the battery did you activate the processor all reset for the watch? I do not know on your model where or how this would be activated.

Electronic watches normally have a reset procedure for when the battery is changed. Very important the watch's processor reset is performed after changing the battery. This is not any of the user readings reset. This is a reset for the watch's processor and system. It is sometimes a contact that has to be shorted out with the jeweler's screwdriver, or it is a contact that has to be shunted, or etc., depending on the model. Maybe if you call the support for the watch they will tell you this. Normally they do not like the user opening the watch.

Hey Malcolm, just bought this watch so I hope it is the same. Press the MODE button (bottom left) until you get AL. Then press the STAR/LAP (top left) this gives you the options of turning it off : ON with Alarm or ON with Alarm and CHM (I think this is the hourly chim) or OFF. (Located above the Quicksilver brand mark) Hope this helps!
Carla

I looked at the Quiksilver web site but could not find the model you have.

If you go to thier web site http://www.quiksilver.com/family/index.jsp?categoryId=2978686&sr=1&origkw=watches, you will see a list of watches and clicking on one of them will take you to a page that has "manuals" near the bottom.

Click on this and you will see a heading "analogue watches" but there are no instructions for digital types. If you watch is a digital watch, then I can only suggest that you contact them and ask them to send you a copy.

You can download an instruction manual for your watch here. It will detail how to reset the hands. :)

Tom

I went to the lorus web site which has user manuals for all their watches. Went through the relivent manual whcih gave details on how to reset the stop watch facility.

it's not broken.

let's call the top stopwatch button "a" and the bottom stopwatch button "b." eg, for normal stop watch function press "a" to start timing, press "a" to stop timing, and press "b" to reset.

to reset: press button "a" and "b" simultaneously and release (an easy way to do this is press and hold down "b" then press "a" and release both). this will send both hands spinning. next press "a" intermittently until the second-hand is back to it's desired reset location. then, likewise, press "b" intermittently until the minute hand is zeroed. now with both hands at the correct reset location, again press and release "a" and "b" simultaneously to save these resets and return the watch to normal function mode.

there should be a reset button on the watch have a good look closer but u will have to have something to reset it with you cant use your fingers