Belt my cd changer would not open i took it apart found that the belt that makes it go up and down and in and out was broken where could i find anthor one

Yes it is the belt. The slight aligment.

Part Number VQ776900. I got it online for 99 cents but other places can be up to 7-8.00 dollars. I removed 5 screws on the sides and rear of the case. Took case off. Press the open button and help the drawer open with your hand while the motor tries to. Then remove old belt with pliers or paper clip, etc.
I did not take anything apart on the inside to replace the belt. Push the belt into the player over the larger wheel and then I pulled the belt with a paper clip over the smaller drive wheel.

Take the cover off and inspect for a jammed disc.

If there are no jammed discs you either have a broken belt or stripped gear.

You will have to take the unit apart and inspect, belts are commercially available from electronic stores and are a cheap easy fix!

Let me know if you need more details or guidance.

Cheers!

Kevin

I had a similar problem with my sony cd changer. Took it apart it turned out to be the drive belt a 3 pound part. Got a new slightly smaller one and works well. Very easy to replace.

I just took my DP-R99 out of the closet and powered it up in my garage. After a short delay it reads EE. I took it apart and the belt that drives the laser head up to the CD and pressure disk to make it spin is slipping and never raising the head enough. It looks like the belt has stretched over the years. I am now going to look for a replacement belt and the belt that rotates the carriage since it is also stretched. I will let you know for sure when I install new belts. Hope this helps...

Hi Guys,
Here`s the fix! Took out 6 cd stacker found out makers name, stripped it apart found out why it was`nt working, 1 broken part, unable to get part, so went to Garage Sale bought 6 cd stacker diggerent make $20.00 fit into car and it`s all good now, problem solved. THANKS ANYWAY. mc.

I had the same problem but fixed it by replacing the cd belt which was broken and relined the main cd plate which holds cd to correct position . and god fixed it.

No more errors and now a great cd Hi Fi.

Make sure all s aligned and blow out all dust with an blower or air compressor.

I pull the top plates off blow air into them and replaced a broken belt for cd's and not it's new machine.

You want to fix it than fix at the source.

old is always gold... just follow some tips as i say... open the player with the door ejected clean the lens wit the dry cloth and clean the dust particles in it especially near the rubber belt connected to the dc motor... after that try to play cds it will play...

If this is a cd changer then there is a reset button inside door or on changer some where that you press and hold and it should reset system. If not then unplug from power for atleast 15min. Re-enstall

if you shut cd draw with no cd in, does the laser lens move up or down at all. if it does suspect dead laser pickup. it is very common for lasers to fail