Wf220 how do i get the old bearings out of the drum, with out a bearing puller(cant find one) seems impossible.

take drum out uve nothing to lose

Replace the bearings.... the only solution the machine will have a new lease on life.

Not an easy job. The whole tub needs removed from the machine. And if possible the tub needs split in 2, this gives access to the inner bearing. The bearings need to be removed using bearing pullers. If the tub cant be split then you will need to replace the tub. Would advise getting a professional to carry out the work.

old belt may be streched replace it and it should be ok first make sure there in no water or oil leaking onto the pulley wheel thankyou

SOME FORDS VECHICLE HAD A GREASE CAP REMOVE IT THEN REMOVE COTTER PIN AND NUT LOCK AND NUT.THEN REMOVE THE BRAKE DRUM WITH WHEEL BEARINGS.

Remove drive belt, and spin drum by hand, if it feels rough or noisy, then the main drum bearings are worn.
If no noise from drum, could be a motor prob.
Please rate ,my solution.
Thanks.

Its not impossible but a real battle without the correct tools. If at the back of your washer, you have the main arm assembly, then firstly remove the belt and then the pulley.Undo the nuts holding the assembly and in short, pull that assembly off by pulling it towards yourself. Once off, you will see the bearings and seal that need to be replaced. Once done, reassemble carefully and god luck.

they can be a pig but if you know whot you are doing you can do it in a few hrs just make sure you mark any wires that you take off it help when you put the washer back if you are not useing a press to put the new bearings in use your old ones to tap your new ones in place dont hit then to are or you can damage them hope this helps and good luck

sounds as if the drum bearings have gave way was it noisey b4 this

Two possibles for this are aloose balance block or cracked drum spider.The front block is most prone to coming loose.
To check spider rotate drum little by little and pull towards you to check for movement.
Post back if further help needed.
Thankyou