Have not used for a while, now seems to have no power, is there a reset somewhere, there is power coming in for sure, never a problem with this before, just wont turn on, thanks

First check for adequate air flow. No air flow means a blockage somewhere. If good airflow then next would be the heating element. (Do make sure that both legs of your 220 volt outlet has power)

It sounds like u have a bad ground connection somewhere.I woud start with the battery and check all your wiring connections it could just be a loose connection somewhere.

There is a pulley system in the somewhere and I believe it is broken.

check the power modes ..there are options for the brightness on the power options screen (somewhere in the bottom of the page ..(I assumed you use windows 7 ..)
click right on the power icon on the tray ..or go to control panel and select the tool ..

Reset is by disconnecting the power to it. If it is hard wired into the electrical box, you have to shut of the breaker and then wait a minute and turn it back on. When you power it back, you should hear the pump come on for a minute as part of the diagnostic. If it does not come one, then you have to check the main control, the transformer, the control board.

linksys usually has a reset button on the bottom of them u can hold however this seems like it is probably shorted out and would be in need of a replacement. Sorry.

hello if total dead check the glass fuse inside the washers power supply if blown make sure you use the same rated fuse if blows again then you have a dead short somewhere hope it helps

regards
shaun

It has a reset button and two fuses her is the break down of unit.
http://appliancepartspros.com/partsearch/model.aspx?model_id=257786
but you should get a higher rated microwave.

if there is no lite at all the problem definitely is with either the power cable or the port on monitor.

cable seems more likely tho...try n get a hold of another cable and try. make sure u dnt use a surge. try it directly to a power outlet first. no reset button can help no power situations.

im not to sure if this works with what u got but it should. soft reset: pop out the battery from it wait abit ant then pop it back in turn it on if it still does this then..... hard reset: look at the back of the phone for a little round button to push use like a paper clip or pen, hold it down and the power button down as well until the device powers on. u will loose all ur data on the phone but it shouuld work. if it doesnt then its ur hardware not the software. somewhere they repair cell phones like celltek would be able to for good price.