Sharp ar 5516 copier error code f2 40 - Sharp AR-5320 Black and White Copier

SOURCE: f2 40 error

http://www.fixya.com/support/t2447657-ar_5320_shoeing_f2

SOURCE: error code Sharp AR-M 257

The F2-04 error code you are getting is that you are using the wrong toner.It may be form sharp,but it toner chips is different.Only the chips swapping at the toner back can help you.

SOURCE: Sharp Copier AR -407 Error code H3-00

H3-00 means there was a problem in the fuser unit of the copier - a temperature problem. The correct temperature is not reached within a certain time.
It could be a thermostat or thermistor problem - both monitor temperature. you could remove the fuser unit and make sure these items are clean - no build up on them. there should be a center and side thermistor.
You can reset the error code in SIM mode by pressing the following keys one after the other "P" "interupt" "C" "interupt" then 14 and start/copy key. confirm if required. make sure the copier is restarted afterwards.
If the error persists then you may need new thermistors.
Hope this helps.

SOURCE: H2 problem sharp AR 5516

is that mean, I have going down to simulation by pressing # interrupt 0 interrupt then machine wil shutdown mode than press 14 then press start.


is that true? because I mess up with my copier cannot print because code H2.