Javelin viper 1.5 POS

cable has 20 or 24 pin group it will only go in one way

i will sell you my javelin pos it's a viper

i have a working javelin viper i will sell

(1) Remove memory from mother board and start the system if you happen to listen long beep then RAM is not working properly.
(2) Clean RAM conducting area on mother board with clean cotton cloth, put one peice of RAM and test and check the othe peice also, if working you could any sign display . Before doing all these check mother board any LED is glowing if so your SMPS is working after you turn on UPS.

(3) Check for all proper connection for all cables. Have you connected video cable of monitor to mother board VGA (it will not work because it is disabled as soon as you installed XFX GeForce 8800 GT), your viedo output only will come through XFX GeForce 8800 GT VGA port.

(4) If propelm persits Deassmble complete the system and reassmble & do n't connect HDD, DVD, floppy. Cehck with bare mother baord, processor, RAM (put one picese at a time) by connecting viedo cable of monitor

THere are two possibilities
1. problem in mother board
2. problem in monitor

To make sure if possible connect your CPU to another monitor and see if all is fine. If the other monitor works fine, then your monitor has th problem
if the other monitor also has lines, then the mother board's video card has prob.

Also check the connection wire between the CPU and monitor that there is no loose contact or any cuts or damages in the wire

have you tried installing the camera's drivers?

YEAH SURE,, its quite easy actually

Go to the manufacture's web site if your main board or network card
in the support link, search your model device and download the driver for it..

of you can just pop any main board cd in for you and it should use the default driver as most is standered LET ME KONOW IF OU HAVE TROUBLE LOCATING IT ON THE PAGE OR IF IT AINT AVIABLE

is the hard drive set to master or slave?

Check the bios and see if it is listed.

What operating system are you using?

HELLO MR GRUMPY I HAVE A SOLUTION FOR THIS IF YOU CAN DO IT YOURSELF ALL YOU NEED IS A PP9 6 VOLT BATTERY 2 WIRES AND 2 PINS THIS INJECTES 6 VOLTS ..... THE 360,S SOUND COMPATABLITYS ARE __Audio __Multi channel surround sound output __Supports 48khz 16-bit audio __320 independent decompression channels __32 bit processing __256+ audio channels ....__..........................................__PLEASE DICONNECT ALL RF LEADS /POWER SUPPLYS/WIRED PADS FROM 360 BEFORE TRYING THIS AND ANY DISK IN THE CONSOLE TAKE 360 APART TILL YOU HAVE THE 360 BOARD IN FRONT OFF YOU USE THE GRAPH ON THE BOARD I HAVE POSTED AND FIND THE PART ON THE PIC LOCATION 8N/8P MEANING 8 POSITIVE 8 NEGITIVE ......__NEXT BATTERY WITH 1 WIRE COMING FROM NEG AND 1 WIRE COMING FROM POS YOU ONLY HAVE TO TOUCH POS WIRE TO POS LOCATION ON BOARD AND NEG TO NEG ON BOARD BOTH AT THE SAME TIME NOW PUT YOUR 360 BACK TOGETHER ....WARNING DONT PUT NEG TO POS OR VICE VERSA I WONT BE HELD RESPONSIBLE FOR ANY DAMAGERS ETC

The Viper is network-ready with an integrated 10/100BaseT controller. why would you need one?