I have a 2005 chev impala can i replace my high beams headlights with just low beam lights

You can't use High Beams as dipped, the spread is different. Just go to another garage, it can only be the bulbs, the connection, the fuses or the relay. In fact you can check all those yourself! It appears to be a known issue on the Impala. Look at the videos

https://www.google.com/search?q=2000+chevy+impala+headlight+problem

Fuse Box Diagram Chevrolet Impala (2000-2005)

https://fuse-box.info > chevrolet > chevrolet-impala-20...
It is located on the passenger's side of the instrument panel, behind the cover. The location of the fuses in the passenger compartment: Chevrolet Impala (2000- ...

..

bad connection or bad earth check all connection or bulb

ok when push the lever forward the high beams don't stay on ? then that lever should be replaced cause that's ur dimmer switch to switch between high/low beam lights if the lever is bad can surge you headlight and blow the headlights, have you check headlight bulbs its rare but it has happened that both blow at the same time

If the bulbs are good then could be a fuse or relay, high beams and low beams are always on seperate fuses and relays.

First it is possible that both low beam filaments in bulb are burnt. Check fuses for low beam before replacing the bulbs.

Hello, on the van you have a high beam fuse and relay. On the low beam you also have a fuse and relay. Check the fuse/relay panel for a blown fuse controlling the low beam lights. If you do not find a blown fuse have some one to turn the key on and turn on the high beam lights. During this time locate the low beam headlight relay and place your finger on top of relay, have the other person to switch from high beam to low beam lights. You should feel a click in the relay when they make the switch from high to low beam. If not replace the relay and the problem should go away. Hope this will help you.

Thanks

On the van you have a high beam fuse and relay. On the low beam you also have a fuse and relay. Check the fuse/relay panel for a blown fuse controlling the low beam lights. If you do not find a blown fuse have some one to turn the key on and turn on the high beam lights> During this time locate the low beam headlight relay and place your finger on top of relay, have the other person to switch from high beam to low beam lights. You should feel a click in the relay when they make the switch from high to low beam. If not replace the relay and the problem should go away. Hope this will help you.

ok put the ground back were you cut it and remove bezel near head light switch test powers in and out with 12 volt test light on low beam and high beam you may just have a bad head light switch make sure you have headlight power coming out of the swicth for low beams.

The hi beams when activated will have all headlight on. If you have to hold the swith in to keep them on that means the switch will not click into the locking mode to keep them on for you. Once you pull back the lever you should hear a faint click. That will lock the high beams on. Pull it again and the same click will be heard and that releases the high beams to off

Honda Headlight Bulb(H1) - This bulb is the high and low beam bulb for your vehicle. One bulb required for each headlight.

This headlight bulb fits:

• CR-V 2005-2006 (requires 2 bulbs per side)