My wii fit board power button not staying on just flashes tryed to sync but still not working

Have you replaced the batteries and you also need to press the SYNC button inside the battery cover underneath the wii board and the SYNC button on the Wii console at the same time.

You have to insert a wii fit game and bypass all the stuff until the game is ready to play.Open the battery compartment on the Wii board and open the large door on the front of the Wii console.Press the sync button on the board,then press the sync button at the top of the console compartment.The fit board light should stay steady blue.If it doesn't,try it again.When the fit board stays steady blue,it is synched.

Hope this helps

Try these steps!


1. Insert a Wii Balance Board compatible game disc in the Wii console.


2. Use the Wii Remote to select the Disc Channel from the Wii Menu, then select "Start" to begin the game. Press the A Button to bypass the wrist strap screen.


3. Open the small SD Card slot cover on the front of the Wii console.
4. Remove the Battery Cover on the bottom of the Wii Balance Board.
5. Press and release the SYNC button on the Wii Balance Board. The blue light on the board will start blinking.
6. Press and release the red SYNC button on the Wii console while the blue light on the board is still blinking.
7. The blue light will stop blinking and stay on steady once the synchronization is complete.

please leave a good rating and testimonial if you appreciate my help. THNX

Make sure that you have synced the board to the wii (similar to a controller). You have to take the battery cover off the board and push the sync button. The blue light will start flashing. From there you need to open the front cover of your wii under the power button.

From there you start up wii fit and it will prompt you to turn on your board. You should get a solid blue light. If you don't, you may need to try syncing again.

Hello,

Here you have different procedures on what to do if you get that error message. Please get back to me if nothing works.

The exact procedure is:

• Even if the battery level is strong, try the following:

Remove the batteries in the Wii Fit Board for at least 1 minute…… better 15

Try these steps!

1 Turn the Wii console power OFF by pressing the POWER Button on the front of the console. Unplug the power cord from the wall outlet for a few seconds. After a few seconds have elapsed, plug the cord back into the wall outlet.

2 Turn the power of the Wii console ON. When you see the Health and Safety screen, open the small flap on the front of the Wii console to find a red button labeled "SYNC." Press and hold the SYNC Button down for 15 seconds. This will clear all the syncs on the Wii, allowing you to get a clean start to begin the process described below.

3 After holding the SYNC Button on the Wii console down for at least 15 seconds, you can now "re-sync" your Wii Remotes:

a With the first Wii Remote you wish to sync, remove the battery cover on the back of the Wii Remote to find a small red button just below the batteries.

b Press and release the small red button just below the batteries on the Wii Remote; the blue lights on the front of the Wii Remote will blink.

c Quickly press and release the red SYNC button on the inside of the white flap on the front of the Wii console (picture).

d When the Player LED blinking stops and stays lit, the syncing is complete. The LED that is illuminated indicates the player number (1 through 4).

4 Start the game from the Wii Menu, then sync the Wii Balance Board from the opening screen of the game.

Hope it helped.

get a new board or get it fixed,
try different batteries
dont put any unessessary weight on it
dont stomp on it or jump
be gentle with it
get a new peice so no re-scyn
make sure its not too close too the wii

Best suggestion is to make sure the game is fully loaded before pressing the power button.

If it's not working, make sure you press the red sync button on the Wii Fit Balance Board AND the Wii Console.

I know you tried new batteries, but make sure they are really NEW batteries (My experience is that the alkalines work best).

If it still doesn't work, then you may need to contact Nintendo direct.

Good luck!

Ensure batteries are fresh. Ensure that Wii Fit (or other Balance Board game) is started up completely before pressing the power button.

Ok I feel a little silly, there is a sync button on the console (inside the flap by the power on button) and the board (inside the battery compartment on the underside of the board) as soon as I pressed them at the same time it worked. Goodluck everyone.

Try these steps!


1. Insert a Wii Balance Board compatible game disc in the Wii console.


2. Use the Wii Remote to select the Disc Channel from the Wii Menu, then select "Start" to begin the game. Press the A Button to bypass the wrist strap screen.


3. Open the small SD Card slot cover on the front of the Wii console.
4. Remove the Battery Cover on the bottom of the Wii Balance Board.
5. Press and release the SYNC button on the Wii Balance Board. The blue light on the board will start blinking.
6. Press and release the red SYNC button on the Wii console while the blue light on the board is still blinking.
7. The blue light will stop blinking and stay on steady once the syncronization is complete.