Medion E1210 notebook. Battery has suddenly stopped charging. Didn't get a fall. Laptop works fine when power supply connected, but if plugged out laptop shuts down immediately. When power plugged in battery light on laptop is flashing red. Can battery have failed completely so quickly?

Whenyou connect the power adapter into the laptop, does the power LED lightup? If not then -The battery adapter or the adapter's power lead or the laptop's powersocket could be faulty.Check power adapter's DCplug that connects into the laptop power socket with a multi-meter, the voltageshould be slightly higher than the voltage that is printed on the label on thebottom of the adapter. If the voltage is zero or way below the voltage that isprinted on the label then the power adapter is faulty and needs to be replaced.If the adapter is OK thenconnect it to the laptop and power it up, then look at the power/batterycharging LED light and wriggle the power plug in the laptop's power socket.If the power/battery LED light flashes and in a certain position this LED lightstays firm, then the power socket is either faulty or it has a dry solder jointwhere it is connected to the motherboard.This can be repaired but itrequires the laptop to be completely dismantled to get at this power socket andrepair. If you cannot DIY then I suggest you get a quote first.

If it works, yes you can. It maybe that the battery went dead.

Try removing the battery for 10 minutes and put it back and see if the laptop powers on. If it doesn't, connect the power cord and see if it is charging. If not, then most likely battery is dead.

You can buy batteries from stores like ebay.

did you try the ac adapter those go bad too, the amount of voltage coming out of the adapter is not higher than the batteries out put voltage, then the battery wont charge
try the ac adapter

i need all draiver of mdion akoya E1210 Notebook

Failure to boot PXE 061 is a BIOS message that indicates 2 things:

1. System failed to boot to the hard drive
2. System failed to boot to a network connection

The apparent problem is failure to boot to the hard disk. If the system was running yesterday and there have been no hardware changes to the system, then most likely failures are:

1. HDD failure (Replace the HDD, reinstall OS and applications) I hope you have information backed up.
2. HDD not being detected by the motherboard due to connection issue (Remove HDD and reseat it, then see if seen in BIOS) If no change replace hard drive, if new drive not seen, replace motherboard

A questions are to be asked here. Does the laptop work when connected to AC power supply? If yes does the battery charge when connected to AC? If yes does this turning off happen when running on battery too? Please answer these questions so that I can help you with the diagnosis.

Regards,
Sai.

Check you adapter for voltage at the connector you insert into the laptop. Just because you see a lit LED on the adapter, doesn'tmean you have output at the connecter, there could be a break in the wire,typically at the strain relief molded area at the connector.

Akoya Mini E1210 is basically an MSI Wind U100, so you could download the english manual from this link1, or this link2.
Happy downloading.

Those may have 1 or 2 different problems. Cold Solder joint on Mobo. Bad DC Power Jack. 1: if it is the Cold Solder, you can reflow the solder and be done with it. 2: if it is the DC power jack, It should be replaced. For simplicity lets call them DC(A) and DC(B) There are 3 connections to it. Gnd, DC (A), and DC (B). When the powersupply is plugged in, contacts (A) touch to send +DC to the laptop. (B) is open. When the laptop is using battery power, contacts (B) touch to send power from the battery through the system. Over a period of time (inserting and removing the DC Power Cord), the contacts become fatigued, or oxidized and the DC(B) never closes - so it won't work from DC Battery. RATE ME - if it helps