I have a Ryobi set ( elec saw, jack saw, tourch and drill,but my battery charger has gone kaput! I will like to buy a new battery charger BC-144T so I can use my Ryobi set. Where I can buy a new battery charger?

home depot -lowes -most hardware stores--go online to buy the replacement for repair do a search for tool repair store in your area but might be cheaper to do replacement

The battery problem, buy new Ryobi batteries.

sounds like the batteries have lived their useful life..
Best regards
Ck

was this battery ever left on the charger too long?
Once rechargeable batteries start to fail holding a charge they should be recycled and you'll have to buy new ones

you shouldnt have a problem with it, but you can also go to their webpage and research there if there is any farther doubt.

It sounds like you drained the batteries down as far as they will go. This happened to me and then I purchased the 18V Lithium-Ion battery and charger. I was able to re-charge the drained battery on the new charger. This may work for you as well. They cheapest solution for you is to just purchase a new battery.

The battery isn't any good. The charger is just going through it's regular steps. (I know how it is. I just bought two Ryobi 18 volt batteries for my Ryobi cordless drill, reciprocating saw, flashlight,
trim circular saw, combo set. $60 for two batteries)

something is wrong. take it back if possible.

Just was on a website for Ryobi drills and it states that if the yellow and green light stay on for more than 15 minutes the battery is fried. Couldn't find the link but if you do a search for Ryobi Drill 18 volt you should find the same info. It was as product review from Australia I think.

I also have a problem with the charging of Ryobi batterys. They seem to charge AOK with the green light coming on but the charge does not last at all. Not sure if the problem is with the batteries on the charger.

Ryobi web site lists the new part numbers for consumables, but by saw model
go to
https://www.customernation.com/pls/ps/ps.ps_main?p_host=329&p_supplier=5060&p_parm=PSHPP
and put in the model number of the saw, and it should punch out current part numbers