Can't find the paper that is jammed in the printer (laserjet 2600n) its says its in the output bin

Jamn output bin". When I open the door, and clear the jammed paper, it still show the problem.

I want to ask u one thing how this problem occure any bdy hv open the fuser if so then check the o/p bin flaps stucks inside open & refix them ur problem hv resolved

Hi,
Just try the steps
Jam in output bin - fuser area Error messageJam in output binalternates withOpen door and clear jam DescriptionA paper jam has occurred in the output bin near the fuser area. Action

1. Clear the jam.
2. Press the (SELECT) button on the control panel.
   

Jam in output bin - duplex area Error messageJam in output binalternates withOpen door and clear jam DescriptionPaper jam in duplex reversing area Action

1. Clear the jam.
2. Press the (SELECT) button on the control panel.Please Rate my response!!!Thanks, SF
   

my experience says jamming in duplex area using card stock. this may occur if default is duplexing. set default to single side and / or try same job using plain a4 80gm2

this is a common fault. look where the paper was jammed, you may need a torch. There is a black or white sensor there that has been dislodged. Once clipped back into place it will then report to the printer that the paper path is clear and no longer a jam.

Ok if the paper is half way coming out, Two things could be happening.
1.) Either your paper feed tires are Slipping and haven't reached the outpit bin sensor in time.
2.) second problem could be is that the fuser film is worn and is not fuser correctly and needs to be replaced.

Are you getting an Error Codes ???

The printed page comes through the hot fuser at the top of the printer, through the exit rollers an end up in the exit bin.
We cleared a massive paper jam out of the fuser, by removing the grey surround on top of the printer. The plastic hooks that hold it in place get broken in the process, then you will the jammed paper between the fuser rollers, and the exit rollers. A technician can do it for you, but is unessersarly costly.

open the back cover you will see a blue knob , just turn it ,jamming paper will coming out

That part is the fuser unit and is hot if the printer is on. Here are instructions for you. Good Luck!

http://www.laserpros.com/pdf/HP%202600-2605%20fuser-etb.pdf

Hi,

Jam in output bin - duplex area
Error message
Jam in output bin
alternates with
Open door and clear jam
Description
Paper jam in duplex reversing area
Action

1. Clear the jam.
2. Press the (SELECT) button on the control panel.
3. If the problem continues, contact HP Customer Support Center for technical assistance at http://www.hp.com/support/clj2600n or see the flyer that came in the printer box for additional contact information.

Jam in output bin - fuser area
Error message
Jam in output bin
alternates with
Open door and clear jam
Description
A paper jam has occurred in the output bin near the fuser area.
Action

1. Clear the jam.
2. Press the (SELECT) button on the control panel.
3. If the problem continues, contact HP Customer Support Center for technical assistance at http://www.hp.com/support/clj2600n or see the flyer that came in the printer box for additional contact information.

Goodluck..