I need an owners manual for RCA F265216BC 25" tv

Here's a link to the RCA RCR314WR remote control user manual and code list:
Information Owner Manual Remote Code List and Support for the RCA RCR314WR...

Click on the link for the codes to find the code you need for your RCA TV

Are you needing a owner's manual as stated or a troubleshooting manual? A troubleshooting manual can be found here: http://www.manualslib.com/manual/138985/Rca-L26wd12.html

An owner's manual can be found here: http://www.umlib.com/brand/RCA/category/TV/model/L26WD12 or here: http://www.retrevo.com/support/RCA-L26WD12-TVs-manual/id/404ag703/t/2/

You can find module replacements here: http://www.shopjimmy.com/rca/l26wd12/

You need to reset the laptop video screen output resolution and refresh rate to something compatible with the HDTVs acceptable parameters. Consult the TVs owner's manual for a chart showing the acceptable screen resolutions and refresh rates. You are looking for numbers like 1024 X 768 or 600 X 800 for screen resolution. Your laptop will allow you to setup different screen resolutions for output. You just have to find one the TV likes.

If those are rca jacks on tv being used to go to amp ?
Are you sure they are not input TO tv rather than outputs ?
YOu must use the AV out connectors on TV to go to amp.
25 inces is fine.

---

Please dont forget to vote if you liked my answer

thanks

------

The output from the blu-ray is probably component video, where the brightness, blue and red difference signals are the three outputs. Sounds like the TV only has composite video input so won't work. Check the manuals, if you can get a composite signal from the blu-ray then your TV will display it but not high definition. A HD LCD or plasma TV is needed to show the blu-ray films in high definition.

Hello, your post shows that you need an owners manual for an 208 RCA TV, I suppose t's a type O and that you mean a 2008 RCA TV. You can download on PDF file almost any owners manual from the RCA website(rca.com) just click under support and provide the correct model number.

you need dish network remote control manual for codes.

Your power supply is most likely faulty. Very common especially in newer tv's. I would call around and get quotes from a few different people first. Unless you want to order a service manual and try to test for the faulty capacitor or resistor in the power supply and replace it yourself.

The manual for this remote can be downloaded for free in PDF format from:
http://safemanuals.com/user-guide-instructions-owner-manual/RCA/RCR450-_E

I actually found it while searching for the RCR451, but it works on RCR450.

Important !!

1) Press "device" button, release
2) Press "device" and "on/off" at same time until indicator light stays on
3) Press "on/off" until device EITHER turns off or goes to (device) menu
4) Press "Stop" key to store the code

I used this control and method to program a Fisher VCR, a Zenith DVD/CD player, and a Quasar 25" TV.

Good luck !!

owners manuals or user guides are availble online at rca.com