My dsl light will flash red when im surfing in the web and then it will restart normal for about an hour then the same thing will happen so what should i do ive reboted the system and power cycle it and rewired it

Hi...
The DSL light if it flashes in green, then it says it is trying to establish a connection with ISP...
Changes to red says "failed to establish the connection"...

The DSL light usually flashes green if there is a lot of noise in your telephone line...so it is also advised to do a line test for your connection...

--->> Recycling the Modem is a good thing, definitely you will be getting a good answer from some tech...

You may have a conflict with the program. Try to reload the software again to see what happens.

you just hit by trojan virus, update your anti-virus

When the DSL light turns red it indicates that the modem has no internet signal.
So please check if the cables are connected properly
Also ensure that there is a proper signal to your premises without any interference
This is called intermittent connection
If the DSL light turns red it indicates that there is a problem with the cables connected or the DSL line
Please check your DSL connection with ISP

There is on another reason that the modem might have gone bad.
If all the above steps are executed and if this issue still persists replace the modem

Hope your tried switching off the machine for half to one hour, to re plug. Machine might re-set.
If helped, pl click, it could help others.

see if youre disk is cracked in the circle and make sure all the cords are plugged

Contact verizon if they can replace the router becase the internet light should be green and flashing as you use the internet.

sounds like a flaky power supply or lamp ballast

Hi,

I had the same problem to begin with. Here is what the Zoom helpdesk suggested:
"To force the dsl light to stop blinking, please follow these steps.

1) Open up your web browser and type 10.0.0.2 in the address bar. Type in the the username and password to log in to the modem.
username: admin
password: zoomadsl

2) When you get to the address bar, Click on advance setup.

3) Click on ADSL Configuration.

4) Change the standard to G.Dmt and change the activate line to Start.

5) Save changes and then write settings to flash.

Within a 1 or 2 minutes, the dsl light should go solid."

This worked for me. Good luck.

Saw this on another post for this router: "in the DHCP configuration on LAN menu. the lease time was set to 72 hours (3 days) i change it to 720 hours, cos that was the most it would allow... so hopefully that would fix it. " maybe you're having the same problem. another usefull thing to do is to update the firmware from the D-link site. some stability issues such as this should be fixed by a firmware update. post what happened goo luck ;]