Just got a new Fuse. How do you unlock. How do you get to a manual?

no fuse for anti theft ---lock and unlock manually only thing is if to slow to put key in ignition alarm will go off but goes off/ resets when turn key order a new fob online their cheap

try it with the fuse in.

no one fuse, check the connections for switch, one may have been knocked loose. does lock open manually and is it hard? actuator may have failed or rubbing and resisting . hope this helps

follow the steps and fix it. God bless you

1. • 1 Enter the passenger side of the vehicle and look under the dashboard, beneath the glove box and near the floor mat. With the aid of a flashlight, locate a large panel, which is held in place by screws. Unscrew the panel manually or use a screwdriver if the screws are too tight.
     
   • 2 Locate the fuse panel. The panel houses long rows of fuses mounted to the panel. Consult the vehicle's owner manual to determine which of the fuses controls the automatic doors
     
   • 3 Remove the fuse that controls the automatic doors with a pair of fuse pliers, or carefully with a pair of regular pliers. Examine the fuse by shining the flashlight close against it. If the metal bar inside the fuse is broken, the fuse has been blown.
     
   • 4 Replace the blown fuse with a fuse of equal amperage. Push the new fuse in place, confirming it is a snug fit.
     
   • 5 Test the automatic doors before screwing the fuse panel cover back in place. If the doors close automatically after you manually give them a tug, the problem was the blown fuse. Replace the fuse panel cover under the glove box.
     
   • 6 Test the automatic doors with your remote control. If they do not open or close, the problem is with the remote. Pop the rear cover off of the remote with a screwdriver and replace the battery.
     

There is a fuse box under the right rear seat cushion behind the driver. In that box is a 10 amp mini fuse marked "TRUNK DR RELEASE". That is the fuse that powers your remote receiver. If that fuse is good, the receiver may have failed. To remove the seat cushion, pull the front of the cushion up and then forward.

It sounds like a blown fuse, check your manual to find out wich fuse feeds the power locks , and it's probably blown, replace it with another of the same amperage, that should solve the problem.

try putting the key in and turn to unlock position,and hold, while holding, press the unlock button on the fob, it may reset it, if not, try unlocking the trunk

happened to me once. the fuse for it was blown. $3 fuse replacement. check the fuse box & manual for this component. the fuse removal tool is located inside the engine fusebox area, and the fuse for the lock is inside the driver side box.

Hello, we have a 2003 Kia Rio- problem as above- unlocking and then locking- only way in and out through passenger door.
This is what I have done and everything is back to normal- I hope it works for you.
1 Remove 25AMP fuse that controls door central locking from main box under the bonnet.
(AT this stage my passenger door opens- drivers side does not, the mechanism won't fully rotate)
2, Spray key with WD40 (or similar moisture repellent lubricant). Gently turn key to loosen mechanism- Partly remove key and spray lubricant into lock, have fun locking and unlocking!
3, Replace 25 amp fuse
4, Write yourself a cheque for garage labour and parts and wife brownie points!